Silicon etching mechanisms in a CF4/H2 glow discharge
- 15 July 1987
- journal article
- conference paper
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 62 (2) , 662-672
Abstract
Fluorocarbon film deposition onto Si and its influence on the measured Si etch rate in CF4/H2 reactive ion etching in a symmetric two electrode reactor has been studied as a function of CF4/H2 feed gas composition, total gas flow, and applied rf power. For reactive ion etching, the fluorocarbon film thickness on Si increases as the percentage x of H2 in CF4/x% H2 is increased. The fluorocarbon film thickness depends on the total gas flow and is greater for greater gas flows. The observed Si etch rate is controlled by the fluorocarbon film. The Si etch rate is directly proportional to the inverse of the F,C‐film thickness for fluorocarbon films thicker than ∼10 Å, which may indicate a diffusion‐limited mechanism. Both in‐diffusion of fluorine and out‐diffusion of SiF4 etch product through the fluorocarbon film are consistent with the decrease of the Si etch rate. The relative importance of the lowering of the atomic F concentration in the gas phase on the Si etch rate, e.g., by the H scavenging mechanism, has also been studied. This reaction can be important for conditions where either the inner walls of the etching apparatus can be maintained free of C,F film throughout the etching experiment, and/or a low hydrogen concentration (≤20%) in the CF4/H2 feed gas is used. For a fixed gas composition of CF4/40% H2, the rf‐power dependence of the C,F‐film thickness and of the Si etch rate was studied. In reactive ion etching, i.e., if rf power is supplied to the bottom (substrate) electrode, at first a monotonic rise in deposited fluorocarbon film thickness with increasing rf power is observed; at high rf‐power levels a dramatic decrease in the C,F‐layer thickness occurs, which is concomitant with a greater intensity of near surface lattice disorder (from ion channeling studies) and Si etching. Silicon etching is not observed for lower rf powers. In cases where rf power was supplied to the top electrode only, C,F‐film deposition has been observed and no Si etching. These data are consistent with a recombinant model of etch anisotropy.Keywords
This publication has 20 references indexed in Scilit:
- Mechanism of silicon surface roughening by reactive ion etchingSurface and Interface Analysis, 1986
- Plasma-deposited fluorocarbon films on silicon studied by ellipsometryThin Solid Films, 1986
- Summary Abstract: Mechanisms of polymerization in discharges of fluorocarbonsJournal of Vacuum Science & Technology A, 1985
- Near‐Surface Damage and Contamination after CF 4 / H 2 Reactive Ion Etching of SiJournal of the Electrochemical Society, 1985
- Study of silicon contamination and near-surface damage caused by CF4/H2 reactive ion etchingApplied Physics Letters, 1984
- Silicon Damage Caused by Hydrogen Containing PlasmasJournal of the Electrochemical Society, 1983
- Parameter and Reactor Dependence of Selective Oxide RIE in CF 4 + H 2Journal of the Electrochemical Society, 1982
- Selective Etching of Silicon Dioxide Using Reactive Ion Etching with CF 4 ‐ H 2Journal of the Electrochemical Society, 1979
- Ion-surface interactions in plasma etchingJournal of Applied Physics, 1977
- Control of relative etch rates of SiO2 and Si in plasma etchingSolid-State Electronics, 1975