A Laboratory Study of the Effects of CO2 Injection Sequence on Tertiary Oil Recovery

Authors:

Abstract
The major reason that CO2 stands out as a fluid displacement agent for enhanced oil recovery is because of the adaptability and relatively low cost of CO2 compared with other chemical flooding agents. CO2 miscible displacement could be achieved for a wide spectrum of reservoir oils through an extraction/vaporization process. Even under immiscible reservoir conditions, incremental oil recovery still can be obtained by simple viscosity reduction and swelling of crude oil. Among other desirable properties of CO2 is its high density. At typical reservoir conditions, CO2 is nearly as heavy as reservoir oil; thus, the problem of overriding common to most gas injecting systems could be minimized greatly. In spite of all the advantages of CO2 process, it inherits the disadvantage of high mobility ratio so that the CO2 has a great tendency to channel through the oil, bypassing much of the oil in the reservoir. To alleviate the difficulties, a technique consisting of alternately injecting small CO2 and water slugs has been applied in field tests.1 The injected water interferes with the flow of CO2 to minimize the chance of premature CO2 breakthrough. Another technique, called "programmed slug," has long been applied in polymer flooding to prevent deleterious effects of viscous fingering. More recently, Claridge2 has developed a method for designing graded banks for both polymer and miscible flooding. His study indicates that the use of a graded slug often results in improvement of oil recovery and/or economic attractiveness.

This publication has 2 references indexed in Scilit: