Modeling Package-Induced Effects on Molded Hall Sensors
Authors:
- Jürgen WildeJWJürgen Wilde
- 28 May 2008
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Advanced Packaging
- Vol. 31 (3) , 594-603
Abstract
The consideration of package-induced effects during the design process of microelectromechanical systems (MEMS) sensors is still of major importance in order to estimate its influence on performance and reliability. A method for predicting the influence of the packaging and assembly process on the performance of a Hall sensor is described. The geometry of the device, the behavior of the packaging materials, as well as the packaging process are regarded using this method. At first, the complex material behavior of adhesives and molding compounds was investigated. It is shown, that for modeling the influence of the packaging on the sensor performance correctly, the nonlinear temperature- and time-dependent material behavior has to be taken into account. Differences of the coefficients of thermal expansion of the packaging materials lead to thermo-mechanical stress in the package. Due to the time-dependent material properties, this results in a change of the offset and the sensitivity of the sensor over time and may lead to a sensor working outside its specification. The piezoresistive and piezo-Hall coefficients of semiconductor Hall plates were measured; thereby the stress- and temperature-dependency of the Hall plates were determined. According to the results, package-induced stresses lead to a change of the offset voltage up to 80% of the full-scale while the sensitivity changes by plusmn4 percentage.Keywords
This publication has 11 references indexed in Scilit:
- Comparison of analysis methods for package-induced stresses on moulded Hall sensorsMicrosystem Technologies, 2006
- The influence of package-induced stresses on moulded Hall sensorsMicrosystem Technologies, 2005
- Influence of materials data on the performance modelling in the design of MEMS packages2004
- Hall Effect Devices2004
- Visco-elastic-plastic behaviors of polymer-based packaging materials2002
- Mechanical failure in COB-technology using glob-top encapsulationIEEE Transactions on Components, Packaging, and Manufacturing Technology: Part C, 1996
- Nonlinear piezoresistance effects in siliconJournal of Applied Physics, 1993
- Viscoelastic and viscoplastic stress analysis of adhesive jointsInternational Journal of Adhesion and Adhesives, 1990
- An internal variable constitutive model for hot working of metalsInternational Journal of Plasticity, 1989
- Piezo-Hall coefficients of n-type siliconJournal of Applied Physics, 1988