Compressive Viscoplastic Response of 6082‐T6 and 7075‐T6 Aluminium Alloys Under Wide Range of Strain Rate at Room Temperature: Experiments and Modelling
Abstract
Abstract: In this work, the viscoplastic behaviour of 6082‐T6 and 7075‐T6 aluminium alloys is examined over a wide range of strain rates. Three different testing techniques were applied to this investigation: low‐rate experiments were performed using a regular servo‐hydraulic testing machine, high‐rate tests were conducted using a split Hopkinson bar apparatus and very‐high‐rate experiments were carried out using a miniaturised direct impact test arrangement. The latter testing set‐up allowed for the characterisation of material flow at strain rates up to . These experimental results showed a sharp increase in the rate sensitivity of the materials once a threshold loading rate of is exceeded. This behaviour may be attributed to the presence of viscous drag on high‐velocity dislocation motion. In addition, the thermo‐viscoplastic behaviour of the 6082‐T6 and 7075‐T6 aluminium alloys was analytically described using the extended Rusinek–Klepaczko model of viscous drag effects. Satisfactory correlation was observed between the experiments and the constitutive model results over the entire range of strain rates studied,Keywords
This publication has 47 references indexed in Scilit:
- Thermo-viscoplastic behaviour of 2024-T3 aluminium sheets subjected to low velocity perforation at different temperaturesThin-Walled Structures, 2011
- Temperature measurements on ES steel sheets subjected to perforation by hemispherical projectilesInternational Journal of Impact Engineering, 2010
- Material aspects of dynamic neck retardationJournal of the Mechanics and Physics of Solids, 2008
- An experimental assessment of friction effects in the split Hopkinson pressure bar using the ring compression testInternational Journal of Impact Engineering, 2007
- Perforation of AA5083-H116 aluminium plates with conical-nose steel projectiles—experimental studyInternational Journal of Impact Engineering, 2004
- Shear testing of a sheet steel at wide range of strain rates and a constitutive relation with strain-rate and temperature dependence of the flow stressInternational Journal of Plasticity, 2001
- Recent development in aluminium alloys for the automotive industryMaterials Science and Engineering: A, 2000
- Characteristics of debris clouds produced by hypervelocity impact of aluminum spheres with thin aluminum platesInternational Journal of Impact Engineering, 1993
- High-velocity dislocation damping in aluminumJournal of Applied Physics, 1973
- The Dynamic Stress-Strain Behavior in Torsion of 1100-0 Aluminum Subjected to a Sharp Increase in Strain RateJournal of Applied Mechanics, 1972