Examining the Uniformity of Flow Distribution in Manifolds
Authors:
Open Access
- 1 May 2024
- journal article
- research article
- Published by Academic World Research in Journal of Applied Fluid Mechanics
- Vol. 17 (5) , 989-1001
Abstract
Flow distribution uniformity in manifolds is important in various engineering applications. In this study, the effect of manifold design on flow distribution is examined using both experimental and numerical methods. A comparison was made between a straight manifold and a gradually decreasing cross-sectional design considering two different inlet diameters. In addition, the staggered manifold case with the most homogeneous outlet was compared with the conical manifold under the same conditions. The results demonstrate that the gradually decreasing manifold design significantly improves the flow rate uniformity compared with the straight manifold. This improvement is achieved by reducing the flow rate differences between the distribution branches, leading to a more balanced fluid distribution. The gradual reduction in the cross-sectional area allows the fluid to traverse at lower velocities in regions with higher resistance, effectively minimizing flow rate discrepancies and pressure drops. In addition, the effect of varying the inlet diameter on flow rate uniformity was investigated, revealing that larger inlet diameters contribute to improved flow distribution. The outlet uniformity of the staggered manifold matches the effective performance of the conical manifold, demonstrating similar performance at a lower cost. The results highlight the importance of designing an appropriate manifold, considering factors such as inlet diameter, channel geometry, and staggered ratio, to achieve efficient and uniform fluid distribution.Keywords
This publication has 21 references indexed in Scilit:
- Influence of using different tapered longitudinal section manifolds in a Z shaped flat plate solar collector on flow distribution uniformityCase Studies in Thermal Engineering, 2022
- Second law performance of a novel four-layer microchannel heat exchanger operating with nanofluid through a two-phase simulationPowder Technology, 2022
- Flow Distribution in U- and Z-Type Manifolds: Experimental and Numerical InvestigationArabian Journal for Science and Engineering, 2020
- 3D CFD simulation of turbulent flow distribution and pressure drop in a dividing manifold system using openfoamInternational Journal of Heat and Mass Transfer, 2020
- Combined hot-wire and PIV measurements of a swirling turbulent flow at the exit of a 90° pipe bendJournal of Visualization, 2015
- The design, fabrication, and evaluation of a ceramic counter-flow microchannel heat exchangerApplied Thermal Engineering, 2011
- Geometric strategies for attainment of identical outflows through all of the exit ports of a distribution manifold in a manifold systemApplied Thermal Engineering, 2009
- The effect of area ratio on the flow distribution in liquid cooling module manifolds for electronic packagingInternational Communications in Heat and Mass Transfer, 1993
- Flow distributions in manifoldsChemical Engineering Science, 1959
- XVI.Note on the motion of fluid in a curved pipeJournal of Computers in Education, 1927