Piezoelectric property improvement of polyethylene ferroelectrets using postprocessing thermal‐pressure treatment
- 19 September 2018
- journal article
- research article
- Published by Wiley in Polymers for Advanced Technologies
- Vol. 30 (1) , 153-161
Abstract
In this work, biaxially stretched polymer foams with well‐defined cellular structures were prepared from polyethylene via blown‐film extrusion and subjected to corona charging to produce a piezoelectric response. The charging parameters were first optimized in terms of charging voltage and needle distance, as well as the gas type and pressure to investigate their effect on the piezoelectric coefficient (d33). The results show that samples charged under nitrogen (N2) at 100 kPa had better d33 coefficient than those charged under ambient air or N2 at 20 kPa. Moreover, 2 different thermal pressure treatments were imposed to obtain an optimized eye‐like cellular structure with different cell aspect ratios (AR). The results showed that when the cells were elongated in both the longitudinal and transverse directions (higher AR), higher d33 coefficients were achieved. From all the samples produced, the best results were obtained for a longitudinal aspect ratio (AR‐L) of 7.1, a transversal aspect ratio (AR‐T) of 4.6, and a relative foam density of 0.52 leading to a d33 coefficient of 935 pC/N. This coefficient was further increased using reverse charging and multilayered films, reaching a maximum of 2550 pC/N. This value is much higher than typical ones reported so far for any polyethylene and polypropylene ferroelectrets. These results could increase the use of polyethylene in piezoelectric applications as these materials are very attractive for the large‐scale production of electret‐based sensors and transducers due to their low cost and easy processing.Keywords
Funding Information
- Fonds Québécois de la Recherche sur la Nature et les Technologies
- Natural Sciences and Engineering Research Council of Canada (RGPIN-2016-05958)
This publication has 39 references indexed in Scilit:
- Continuum modeling of charging process and piezoelectricity of ferroelectretsJournal of Applied Physics, 2013
- A review of wearable sensors and systems with application in rehabilitationJournal of NeuroEngineering and Rehabilitation, 2012
- Piezoelectric Properties of FerroelectretFerroelectrics, 2011
- Cell morphology analysis of high density polymer foamsPolymer Testing, 2005
- Numerical calculations of effective elastic properties of two cellular structuresJournal of Physics D: Applied Physics, 2005
- Charged cellular polymers with "ferroelectretic" behaviorIEEE Transactions on Dielectrics and Electrical Insulation, 2004
- Two-step inflation of cellular polypropylene films: void-thickness increase and enhanced electromechanical propertiesJournal of Physics D: Applied Physics, 2004
- Dielectric resonance spectroscopy: a versatile tool in the quest for better piezoelectric polymersIEEE Transactions on Dielectrics and Electrical Insulation, 2003
- Less can be more. Holes in polymers lead to a new paradigm of piezoelectric materials for electret transducersIEEE Transactions on Dielectrics and Electrical Insulation, 2002
- Electromechanical response of cellular electret filmsApplied Physics Letters, 1999