Evaluation of Pulsating Pressure and Emitter Position in Preventing Drip Emitters from Clogging
- 1 March 2022
- journal article
- research article
- Published by American Society of Civil Engineers (ASCE) in Journal of Irrigation and Drainage Engineering
- Vol. 148 (3) , 06021015
Abstract
Non–pressure compensating (Non-PC) emitters are employed mainly in drip irrigation systems due to their structural simplicity and low manufacturing costs; however, they present high sensitivity to physical obstruction, even when using filtration. This research aimed to analyze the effects of pulsating pressure, constant pressure, and water exit position in terms of preventing clogging in Non-PC drippers with a labyrinth system. The tests were performed on a test bench, and each treatment had 68 drippers (repetitions). Quartz sand was added to the irrigation water at a concentration in two granulometric ranges (53–105 and 250–500 μm) to reproduce field conditions. The performance indicators were emitter flow rate ( ) and relative flow rate ( ). For the 250–500 μm granulometric range and the emitters positioned with the water exit facing downward, the 30 s constant pressure and 1 min pulsating pressure resulted in the obstruction of all emitters with only 2 h of operation. In the 53–105 μm granulometric range with the emitter hole facing downward, a pulsating pressure with a 1 min cycle was the most efficient at delaying emitter clogging, showing during the first 16 h of operation. When the dripper exit was positioned facing upward in the most critical situation (constant pressure), no clogging was observed within the two granulometric ranges during the 40 h test. For this emitter model, which is widely applied in horticulture, a water exit facing upward is recommended to prevent clogging by suspended solid particles.
Keywords
This publication has 21 references indexed in Scilit:
- Effect of drip irrigation frequency on emitter clogging using reclaimed waterIrrigation Science, 2015
- Assessment of clogging effects on lateral hydraulics: proposing a monitoring and detection protocolIrrigation Science, 2013
- Surface topographic characteristics of suspended particulates in reclaimed wastewater and effects on clogging in labyrinth drip irrigation emittersIrrigation Science, 2011
- Structural optimization of labyrinth-channel emitters based on hydraulic and anti-clogging performancesIrrigation Science, 2010
- Anti-clogging performance evaluation and parameterized design of emitters with labyrinth channelsComputers and Electronics in Agriculture, 2010
- Rapid Evaluations of Anticlogging Performance of Drip Emitters by Laboratorial Short-Cycle TestsJournal of Irrigation and Drainage Engineering, 2008
- ANALYSIS OF CLOGGING IN DRIP EMITTERS DURING WASTEWATER IRRIGATIONApplied Engineering in Agriculture, 2006
- Water quality in drip/trickle irrigation: A reviewIrrigation Science, 1991
- Mechanisms and Process Parameters of Filter ScreensJournal of Irrigation and Drainage Engineering, 1986
- Trickle Irrigation: Prevention of CloggingTransactions of the ASAE, 1979