Effect of Blank Holding Force on the Gas Tightness of Paperboard Trays Manufactured by the Press Forming Process
Authors:
Open Access
- 3 February 2015
- journal article
- research article
- Published by BioResources in BioResources
- Vol. 10 (2) , 2235-2243-2243
Abstract
Although several authors have studied 3D forming using the press forming process, the gas tightness of polymer-coated paperboard trays has not been widely researched. In this paper, the effect of blank holding force on the surface quality and tightness of press-formed paperboard trays was researched. The press-formed trays were heat-sealed with a multilayer polymer lid. The tightness of the trays was analyzed by following the oxygen content of the packages over the course of 14 d and by using a penetrant coloring solution to locate possible leaks. The results indicate that the blank holding force had a great effect on the quality and tightness of the trays, especially in the case of a rectangular geometry. The geometry of the formed trays played a significant role in process parameter selection, and more demanding geometries emphasize the importance of parameter optimization. However, with the correctly selected parameters, the use of modified atmospheric packaging (MAP) in polymer coated paperboard trays was shown to be possible. The oxygen content of both analyzed geometries was found to be less than 1% 14 d after sealing. It was also demonstrated that the gas tightness of a seal cannot be confirmed using a penetrant solution test exclusively.Keywords
This publication has 7 references indexed in Scilit:
- The Effect of Concave Base Shape Elements on the Three Dimensional Forming Process of Advanced Paperboard StructuresPackaging Technology and Science, 2014
- 3D Forming of Paperboard: The Influence of Paperboard Properties on FormabilityPackaging Technology and Science, 2013
- Combined Effect of Paperboard Thickness and Mould Clearance in the Press Forming ProcessBioResources, 2013
- Thermal and mechanical durability of starch-based dual polymer coatings in the press forming of paperboardPackaging Technology and Science, 2013
- The Elongation Potential of Paper – How Should Fibres be Deformed to Make Paper Extensible?BioResources, 2012
- Deep-drawing of paper and paperboard: The role of material propertiesBioResources, 2012
- New Quality Level of Packaging Components from Paperboard through Technology Improvement in 3D FormingPackaging Technology and Science, 2011