Influence of processing on the mechanical properties and morphology of starch‐based blends for film applications
- 23 May 2019
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 136 (39)
Abstract
This article describes the effect of processing on the properties and morphology of thermoplastic starch (TPS) and poly(butylene adipate‐co‐terephthalate) (PBAT) blends and films with high starch content. Different process parameters were modified during compounding of blends and extrusion of blown films. Morphology was examined through scanning electron microscopy. Mechanical and optical characterization of films was carried out as well. Decreasing specific throughput during compounding led to an increase in strain at break of the blends from 66 to 497%. The tensile strength increased from 6 to 22 MPa as well. The highest elastic modulus and tear resistance were achieved at intermediate specific throughputs, whereas the maximum TPS particle size and the lowest color difference were obtained at high specific throughputs. A decrease of color difference from 6.4 to 2.2 was observed by reducing the temperature profile in 5 °C. In the case of blown film extrusion, increasing the temperature profile resulted in a reduction of color difference of the films from 7.9 to 4.2. In addition, tensile strength and strain at break slightly increased. Color difference decreased with decreasing screw speed as well. © 2019 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2019, 136, 47990.Keywords
Funding Information
- Austrian Research Promotion Agency
This publication has 29 references indexed in Scilit:
- The present and future of microplastic pollution in the marine environmentEnvironmental Pollution, 2014
- Microplastics as contaminants in the marine environment: A reviewMarine Pollution Bulletin, 2011
- Comparison of sorbitol and glycerol as plasticizers for thermoplastic starch in TPS/PLA blendsJournal of Applied Polymer Science, 2010
- Thermal processing of starch-based polymersProgress in Polymer Science, 2009
- Amylose content and chemical modification effects on thermoplastic starch from maize – Processing and characterisation using conventional polymer equipmentCarbohydrate Polymers, 2009
- Synthetic polymers in the marine environment: A rapidly increasing, long-term threatEnvironmental Research, 2008
- Extrusion processing of high amylose potato starch materialsCarbohydrate Polymers, 2006
- Preparation and characterisation of compatibilised polycaprolactone/starch compositesPolymer, 2000
- Starch-Filled PHB and PHB/HV CopolymerPolymer International, 1996
- Influence of amylose content on starch films and foamsCarbohydrate Polymers, 1995