Variation of elastic modulus during plastic deformation and its influence on springback

This publication has 15 references indexed in Scilit:

• The effect of strain-induced martensitic transformation on mechanical properties of TRIP steel
  Materials & Design (1980-2015), 2008
• Experimental and numerical studies of springback in air v-bending process for cold rolled TRIP steels
  Nuclear Engineering and Design, 2006
• Study of the Inelastic Response of TRIP Steels after Plastic Deformation
  ISIJ International, 2005
• Effects of volume fraction and stability of retained austenite on formability in a 0.1C–1.5Si–1.5Mn–0.5Cu TRIP-aided cold-rolled steel sheet
  Materials Science and Engineering: A, 2004
• Elastic and Inelastic Recovery After Plastic Deformation of DQSK Steel Sheet
  Journal of Engineering Materials and Technology, 2003
• Inelastic effects on springback in metals
  International Journal of Plasticity, 2002
• Elastic–plastic behavior of steel sheets under in-plane cyclic tension–compression at large strain
  International Journal of Plasticity, 2002
• Effect of the material-hardening mode on the springback simulation accuracy of V-free bending
  Journal of Materials Processing Technology, 2002
• On the necessity of taking into account the variation in the Young modulus with plastic strain in elastic-plastic software
  Nuclear Engineering and Design, 1996
• Effects of Volume Fraction and Stability of Retained Austenite on Ductility of TRIP-aided Dual-phase Steels.
  ISIJ International, 1992