Effect of rotational speeds on microstructure and mechanical properties of friction stir-welded 7075-T6 aluminium alloy
Authors:
- 21 June 2011
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science
- Vol. 225 (8) , 1761-1773
Abstract
In this article, effects of rotational speed on the microstructure and mechanical properties of friction stir-welded 7075-T6 Al alloys were investigated. Good correlation existed between the rotational speeds and weld properties. It was found that with increase in the rotational speed, higher pick temperatures and wider thickness of the heat-affected zone were obtained, and then grain coarsening, dissolution, and accumulation of hardening precipitates in grain boundaries. The average grain size of nugget increased from 6.8 to 8.9 µm, with increasing rotary speed from 600 to 1550 r/min. In addition, the best mechanical properties were obtained at moderate rotational speed of 825 r/min while ultimate tensile strength and elongation were 405 MPa and 6.1 per cent, respectively. Also, it was observed that at low welding speed of 60 mm/min, the weld properties are found to be dominated by the thermal cycle rather than the plastic deformation induced by tool, so as to make a reduction in hardness and strength of the weld when using higher rotational speeds.Keywords
This publication has 13 references indexed in Scilit:
- Tensile properties of friction stir welded joints of 2024 aluminum alloys in different heat-treated-stateMaterials & Design (1980-2015), 2009
- Influence of friction stir welding parameters on grain size and formability in 5083 aluminum alloyMaterials Science and Engineering: A, 2007
- Microstructure evolution during FSW/FSP of high strength aluminum alloysMaterials Science and Engineering: A, 2005
- Friction stir welding and processingMaterials Science and Engineering: R: Reports, 2005
- Fine-grain evolution in friction-stir processed 7050 aluminumScripta Materialia, 2003
- Microstructural investigation of friction stir welded 7050-T651 aluminiumActa Materialia, 2003
- Friction-stir welding effects on microstructure and fatigue of aluminum alloy 7050-T7451Metallurgical and Materials Transactions A, 2000
- Heat Flow Model for Friction Stir Welding of Aluminum AlloysJournal of Materials Processing & Manufacturing Science, 1998
- Properties of friction-stir-welded 7075 T651 aluminumMetallurgical and Materials Transactions A, 1998
- Friction stir welding for the transportation industriesMaterials & Design (1980-2015), 1997