The manufacturing process of co-cured single and double lap joints and evaluation of the load-bearing capacities of co-cured joints
Authors:
- Kum Cheol ShinKSKum Cheol Shin
- Jeong Ok LimJLJeong Ok Lim
- Jung Ju LeeJLJung Ju Lee
- 1 July 2003
- journal article
- Published by Elsevier in Journal of Materials Processing Technology
- Vol. 138 (1-3) , 89-96
Abstract
No abstract availableKeywords
This publication has 14 references indexed in Scilit:
- Manufacturing of Co-Cured Composite Aluminum Shafts with Compression during Co-Curing Operation to Reduce Residual Thermal StressesJournal of Composite Materials, 1998
- Optimisation of the co-curing of two different composites with the aim of minimising residual curing stress levelsComposites Science and Technology, 1998
- Static and Dynamic Torque Characteristics of Composite Cocured Single Lap JointJournal of Composite Materials, 1997
- Torque Capacity of Co-Cured Tubular Lap JointsJournal of Composite Materials, 1997
- Manufacture of one-piece automotive drive shafts with aluminum and composite materialsComposite Structures, 1997
- Expert Cure System for the Carbon Fiber Epoxy Composite MaterialsJournal of Composite Materials, 1995
- Residual Stresses and Delamination Problems Induced by Cocuring of Damped Composite LaminatesJournal of Composite Materials, 1994
- An Experimental Study of Fatigue Strength for Adhesively Bonded Tubular Single Lap JointsThe Journal of Adhesion, 1991
- Role of matrix resin in delamination onset and growth in composite laminatesComposites Science and Technology, 1988
- Introduction To Composite Materials1987