Galvanic Isolation and Output LC Filter Design for the Low-Voltage DC Customer-End Inverter
- 30 April 2014
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Smart Grid
- Vol. 5 (5) , 2593-2601
Abstract
In this paper the need for a better design of the galvanic isolation and the output filter inductor in the customer-end inverter (CEI) of the low voltage DC (LVDC) network is discussed. The galvanic isolation can be implemented either with a 50 Hz transformer after the CEI or with an isolated DC-DC converter between the DC network and the CEI. However, the 50 Hz transformer solution adds a significant amount of volume and mass to the system. Based on calorimetric measurements conducted with the current system in which the galvanic isolation is implemented with the former method, the minimum requirements for the isolated DC-DC converter are presented and a comparison is carried out. For the system to be cost efficient the DC-DC converter should result in reduced lifetime cost compared with the transformer solution. In the output filter part a design method for an amorphous core filter inductor based on minimization of the lifetime cost is presented.Keywords
This publication has 15 references indexed in Scilit:
- Power density design of SiC and GaN DC-DC converters for 380 V DC distribution system based on series-parallel circuit topology2013
- Experimental and Numerical Analysis of a Simple Core Loss Calculation for AC Filter Inductor in PWM DC-AC InvertersJournal of Power Electronics, 2013
- Advantages of high frequency PWM in AC motor drive applications2012
- High-Efficiency Isolated Bidirectional AC–DC Converter for a DC Distribution SystemIEEE Transactions on Power Electronics, 2012
- Modeling and analysis of DC distribution systems2011
- Low-Voltage Bipolar-Type DC Microgrid for Super High Quality DistributionIEEE Transactions on Power Electronics, 2010
- Configuration and control of a DC microgrid for residential houses2009
- Utilizing Flexible Printed Circuit Board (FPCB) to realize passives integration in LLC resonant converterAPEC 07 - Twenty-Second Annual IEEE Applied Power Electronics Conference and Exposition, 2008
- Measurement and loss model of ferrites with non-sinusoidal waveforms2004
- Power Distribution Planning Reference Book2004