Effects of Large-Temperature Cycling Range on Direct Bond Aluminum Substrate
Authors:
- 13 October 2009
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Device and Materials Reliability
- Vol. 9 (4) , 563-568
Abstract
Substrate reliability has, for a long time, been a concern for systems exposed to harsh environments. State-of-the-art direct bond copper (DBC) substrate is susceptible to large-temperature cycling range. Due to the coefficient of thermal expansion mismatch between copper and the base ceramic (e.g., Al2O3 and AlN), delamination of copper from the ceramic base plate caused by thermomechanical stresses is often observed. In this paper, effects of large-temperature cycling range on direct bond aluminum (DBA) substrate reliability were investigated as it could be a viable alternative to DBC. DBA substrates with different metallizations were thermally cycled between -55degC and 250degC. Unlike the DBC substrate, no delamination of aluminum from the aluminum-nitride ceramic base plate was observed in the DBA substrates. However, it was observed that surface roughness of metallization increased during the thermal cycling test. It is believed that, in the high-temperature regime, the significant amount of thermal stress and grain-scale deformation caused recrystallization and grain-boundary sliding to become very active in the aluminum layer, thus leading to the observed increase in surface roughness. The influence of metallization over the aluminum surface on the extent of surface roughness was also characterized.Keywords
This publication has 16 references indexed in Scilit:
- Effects of metallization thickness of ceramic substrates on the reliability of power assemblies under high temperature cyclingMicroelectronics Reliability, 2006
- Simultaneous grain boundary migration and grain rotationActa Materialia, 2006
- Advantages and new development of direct bonded copper substratesMicroelectronics Reliability, 2003
- Manufacture and Analyses of Ceramic/Aluminum Laminated CompositesKey Engineering Materials, 2002
- Interfacial Versus Cohesive Failure on Polymer-Metal Interfaces in Electronic Packaging—Effects of Interface RoughnessJournal of Electronic Packaging, 2002
- Grain boundary sliding and migration: Effect of temperature and vacanciesPhysical Review B, 2001
- High-temperature deformation of 6061 AlActa Metallurgica et Materialia, 1994
- Thermally Induced Failure of Copper‐Bonded Alumina Substrates for Electronic PackagingJournal of the American Ceramic Society, 1992
- Superplasticity—Recent advances and future directionsProgress in Materials Science, 1989
- Microstructural evolution by continuous recrystallization in a superplastic Al-Mg alloyActa Metallurgica, 1988