Heat treatment and temperature effects on formability of AA2014-T6 in incremental forming
Authors:
- 29 December 2021
- journal article
- research article
- Published by Taylor & Francis in Materials and Manufacturing Processes
- Vol. 37 (12) , 1384-1392
Abstract
Aluminum alloys of various series are used extensively in the auto and aviation sectors because of their low weight to strength ratio. In the current article, one of the hard-to-form aluminum alloys, i.e., AA2014-T6 investigated for its formability and microstructural changes in incremental forming at room and elevated temperature of 250OC. The mechanical properties and formability of the material are evaluated using uniaxial tensile test and Varying Wall Angle Cone Frustums (VWACF), respectively. A novel experimental setup is designed with an induction coil to heat the sheet at elevated temperatures for incremental forming. As-received sheets formed at room and elevated temperature of 250OC, showed less improvement in material formability due to less number of slip planes. Thus, the samples are solutionized at 480OC for 3 hours followed by aging at 180OC for 8 hours. However, much improvement was not observed in room temperature formability, even though the ductility was improved significantly. But, forming at an elevated temperature of 250OC, the formability was enhanced by 956% compared to the as-received material. The formability of the material is correlated with the microstructural modification after solution treatment at room and elevated temperatures.Keywords
Funding Information
- Department of Science and Technology (DST/TDT/DDP-18/2018(C))
This publication has 34 references indexed in Scilit:
- Recent developments in advanced aircraft aluminium alloysMaterials & Design (1980-2015), 2014
- Warm deep-drawing and post drawing analysis of two Al–Mg–Si alloysJournal of Materials Processing Technology, 2014
- Hot incremental forming of magnesium and aluminum alloy sheets by using direct heating systemProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2013
- Guidelines for Tool-Size Selection for Single-Point Incremental Forming of an Aerospace AlloyMaterials and Manufacturing Processes, 2013
- Forming Parameters and Forming Defects in Incremental Forming of an Aluminum Sheet: Correlation, Empirical Modeling, and Optimization: Part AMaterials and Manufacturing Processes, 2011
- Aluminium in Innovative Light-Weight Car DesignMATERIALS TRANSACTIONS, 2011
- High temperature tensile and wear behaviour of aluminum silicon alloyMaterials Science and Engineering: A, 2010
- Effect of Solution Heat Treatment on the Hot Workability of Al–Mg–Si AlloyMaterials and Manufacturing Processes, 2009
- Calorimetric studies of 8090 and 1441 Al–Li–Cu–Mg–Zr alloys of conventional and retrogressed and reaged tempersJournal of Materials Science, 2007
- A calorimetric study of precipitation in aluminum alloy 2219Metallurgical Transactions A, 1981