Reduction of Electromagnetic Noise Coupling to Antennas in Metal-Framed Smartphones Using Ferrite Sheets and Multi-Via EBG Structures
Author:
- 26 September 2017
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electromagnetic Compatibility
- Vol. 60 (2) , 394-401
Abstract
Recent smartphones increasingly employ a metal frame for a sophisticated design. However, the metal frame becomes a good coupling path for electromagnetic (EM) noise within smartphones and increases noise coupling to radio-frequency antennas located at the top and bottom sides of the smartphones. This paper proposes two novel metal frame structures with ferrite absorbing sheets or electromagnetic band gap patterns to reduce the coupling of EM noise to the antenna. Using a fabricated test board, the effects of the proposed metal frames on noise coupling suppression are experimentally validated.Keywords
Funding Information
- University of Suwon
This publication has 17 references indexed in Scilit:
- Physics-Based Dipole Moment Source Reconstruction for RFI on a Practical CellphoneIEEE Transactions on Electromagnetic Compatibility, 2017
- Radio-Frequency Interference Estimation Using Equivalent Dipole-Moment Models and Decomposition Method Based on ReciprocityIEEE Transactions on Electromagnetic Compatibility, 2015
- Estimating Radio-Frequency Interference to an Antenna Due to Near-Field Coupling Using Decomposition Method Based on ReciprocityIEEE Transactions on Electromagnetic Compatibility, 2013
- Bandwidth Enhancement Based on Optimized Via Location for Multiple Vias EBG Power/Ground PlanesIEEE Transactions on Components, Packaging and Manufacturing Technology, 2011
- Design and Modeling of a Stopband-Enhanced EBG Structure Using Ground Surface Perturbation Lattice for Power/Ground Noise SuppressionIEEE Transactions on Microwave Theory and Techniques, 2009
- A Power Plane With Wideband SSN Suppression Using a Multi-Via Electromagnetic Bandgap StructureIEEE Microwave and Wireless Components Letters, 2007
- Coupling Reduction in Enclosures and Cavities Using Electromagnetic Band Gap StructuresIEEE Transactions on Electromagnetic Compatibility, 2006
- A simple and effective model for electromagnetic bandgap structures embedded in printed circuit boardsIEEE Microwave and Wireless Components Letters, 2005
- Electromagnetic-bandgap layers for broad-band suppression of TEM modes in power planesIEEE Transactions on Microwave Theory and Techniques, 2005
- High-impedance electromagnetic surfaces with a forbidden frequency bandIEEE Transactions on Microwave Theory and Techniques, 1999