Analysis of the Parameters of the Two-Sections Hot Side Heat Exchanger of the Module with Thermoelectric Generators
Open Access
Abstract
One of the methods of converting thermal energy into electricity is the use of thermoelectric generators (TEG). The method can be used in low-temperature waste heat conversion systems from industrial installations, but its serious limitation is the low efficiency of thermolectric generators and the relatively low power of the electric waveforms obtained. Increasing the obtained power values is done by multiplying the number of TEGs used, grouped into modules (MTEG). In such systems, the design of the module is extremely important, as it should ensure the best possible heat transfer between both sides of the TEG (hot and cold), and thus obtaining maximum electrical power. The article presents an analysis of a two-section flat plate heat hot side exchanger MTEG. The key parameters like effectiveness of exchange and MTEG efficiency and their impact on the efficiency of heat use and generated electric power were indicated. The tests showed an improvement in these main system parameters for the mixed cycle (co-current and countercurrent—inward direction) of the hot side heat exchanger, compared to the countercurrent flow in both sections of this exchanger.Keywords
Funding Information
- Łukasiewicz Research Network - Institute for Sustainable Technologies in Radom (2/Ł-ITEE/CŁ/2021)
This publication has 20 references indexed in Scilit:
- Bismuth Telluride and Its Alloys as Materials for Thermoelectric GenerationMaterials, 2014
- A review on thermoelectric renewable energy: Principle parameters that affect their performanceRenewable and Sustainable Energy Reviews, 2014
- Thermal Optimization of the Heat Exchanger in the Vehicular Waste-Heat Thermoelectric GenerationsJournal of Electronic Materials, 2012
- Thermal effect of a thermoelectric generator on parallel microchannel heat sinkEnergy, 2011
- Thermodynamics of Thermoelectric Phenomena and ApplicationsEntropy, 2011
- A numerical model for thermoelectric generator with the parallel-plate heat exchangerJournal of Power Sources, 2007
- Optimization of cross flow heat exchangers for thermoelectric waste heat recoveryEnergy Conversion and Management, 2004
- Thermoelectrics: a review of present and potential applicationsApplied Thermal Engineering, 2003
- Modelling heat exchangers for thermoelectric generatorsJournal of Power Sources, 2001
- Evaluation of thermoelectric modules for power generationJournal of Power Sources, 1998