Addressing FinFET metrology challenges in 1× node using tilt-beam critical dimension scanning electron microscope
Authors:
- 1 October 2014
- journal article
- Published by SPIE-Intl Soc Optical Eng in Journal of Micro/Nanolithography, MEMS, and MOEMS
- Vol. 13 (4) , 041407
Abstract
At node, a three-dimensional (3-D) FinFET process raises a number of new metrology challenges for process control, including gate height and fin height. At present, there is a metrology gap in inline in-die measurement of these parameters. To fill this metrology gap, in-column beam tilt has been implemented on Applied Materials critical dimension scanning electron microscope for height measurement. Low-tilt (5 deg) and high-tilt (14 deg) beam angles have been calibrated to obtain the height and the sidewall angle information. Evaluation of its feasibility and production worthiness is done with applications in both gate height and fin height measurements. Transmission electron microscope correlation with an equal to 0.89 and a precision of 0.81 nm have been achieved on various in-die features in a gate height application. The initial fin height measurement shows less accuracy ( being 0.77) and precision (1.49 nm) due to greater challenges brought by the fin profile, yet it is promising for the first attempt. Sensitivity to design of experiment offset die-to-die and in-die variations is demonstrated in both gate height and fin height. The process defect is successfully captured with inline gate height measurement. This is the first successful demonstration of inline in-die gate height measurement for a 14-nm FinFET process control.
Keywords
This publication has 7 references indexed in Scilit:
- Hybrid metrology universal engine: co-optimization2014
- Gaps analysis for CD metrology beyond the 22nm node2013
- The coming of age of tilt CD-SEM2007
- Quantitative profile-shape measurement study on a CD-SEM with application to etch-bias control and several different CMOS features2003
- Quantitative profile-shape measurement study on a CD-SEM with application to etch-bias control2002
- Determination of best focus and exposure dose using CD-SEM sidewall imaging2001
- Shape control using sidewall imaging2000