Calibration Method of Measuring Heads for Testing Residual Stresses in Sheet Metal Using the Barkhausen Method
Open Access
- 18 September 2024
- Vol. 17 (18) , 4584
Abstract
Among non-destructive testing methods, a group dedicated to the assessment of the state of residual stresses can be distinguished. The method of measuring residual stresses using the Barkhausen noise method has many advantages, as evidenced by the number of publications. The residual stresses in metal products are important for the further processing of such metal, such as laser cutting or bending. The results presented in this work are of an experimental nature, and the presented method of calibration of measuring heads shows how various research techniques can be used to correlate results. The research was carried out for structural steel due to the market share of this type of steel. The method can be used to measure the residual stresses in ferromagnetic metal products in order to assess their directions and quantify them. A prerequisite for the use of this measurement method is that the amplitude and geometry of the Barkhausen noise are adequately correlated to the specific values of the state of stress depending on the tested steel grade or other metals. In this study, a method for calibrating measuring sensors for the residual stress measurements is presented, as developed by the authors. The method involved conducting bending tests in both numerical modeling and experimental tests. During the bending tests, changes in the magnetic field (Barkhausen noise waveform) were recorded, taking into account the state of elastic stresses. Correlating the results of the numerical calculations and Barkhausen noise measurements made it possible to determine the quantitative values of the residual stresses in the steel sheets. Thanks to the method used, very accurate measurement is possible, and the obtained results are repeatable.Keywords
Funding Information
- National Center for Research and Development (POIR.01.01.01-00-0477/18)
This publication has 39 references indexed in Scilit:
- Residual stress analysis in industrial parts: a comprehensive comparison of XRD methodsJournal of Materials Science, 2023
- Quantitative measurement of stress in steel bars under repetitive tensile load based on force-magnetic coupling effectMeasurement, 2022
- Experimental study on residual stresses of dual phase high‐strength cold‐formed steel anglesce/papers, 2021
- Directional magnetic Barkhausen noise measurement using the magnetic needle probe methodJournal of Magnetism and Magnetic Materials, 2021
- Recent progress of residual stress measurement methods: A reviewChinese Journal of Aeronautics, 2021
- Barkhausen Noise for Non-Destructive Testing and Materials Characterization in Low Carbon Steels2020
- Barkhausen Noise Probes and Modelling: A ReviewJournal of Nondestructive Evaluation, 2019
- Stress-inheriting behavior of H-beam during roller straightening processJournal of Materials Processing Technology, 2017
- Numerical modeling and experimental identification of residual stresses in hot-rolled stripsArchives of Civil and Mechanical Engineering, 2016
- Fundamental deformation types and sectional properties in roll formingInternational Journal of Mechanical Sciences, 1994