Validation of mineralisation procedures for the determination of selenium, zinc, iron and copper in chicken meat and feed samples by ICP-AES and ICP-MS
- 23 August 2004
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Journal of Analytical Atomic Spectrometry
- Vol. 19 (10) , 1361-1369
Abstract
Mineralisation procedures for determining Fe, Zn, Cu and Se in chicken meat and feed samples were studied. We employed three different sample preparation procedures to determine these elements by ICP-AES and ICP-MS. An open vessel wet mineralisation procedure was used for chicken meat analysis. Here, in the case of the trace elements Cu and Se, it was necessary to concentrate and reduce the acid matrix effects so samples were heated to dryness. However, this procedure causes Se volatilisation losses leading to low recoveries and high variability. Therefore, a closed vessel microwave mineralisation procedure was developed for chicken meat samples. The results obtained using this procedure presented a much lower variability (2.5, 2.0 and 3.1% of RSD for Zn, Fe and Se, respectively) and were consistent with the certified values for the reference material being assessed. Cu content, despite presenting a relatively high variability (RSD = 11%) also agreed with the certified value for the reference material. Recoveries in spiked chicken meat were 103–105% for Zn, 107–108% for Fe, 97–100% for Se and 89–94% for Cu. However, when this procedure was used with feeds, some mineralised samples presented siliceous particles which led to a lower recovery of Zn compared with that recorded when using another microwave mineralisation procedure in which these particles had been dissolved with hydrofluoric acid. This alternative mineralisation procedure for feeds was validated by assessing the precision, recovery and sensitivity when determining each element.Keywords
This publication has 37 references indexed in Scilit:
- Multi-element Analysis of Food by Microwave Digestion and Inductively Coupled Plasma-Atomic Emission SpectrometryJournal of Food Composition and Analysis, 2002
- Mercury and Selenium Content in Selected SeafoodJournal of Food Composition and Analysis, 2001
- Determination of selenium, zinc and cadmium in antidandruff shampoos by atomic spectrometry after microwave assisted sample digestionTalanta, 2000
- Comparison of digestion methods for the determination of selenium in fish tissue by cathodic stripping voltammetryAnalytica Chimica Acta, 2000
- Determination of Arsenic and Selenium in Food using a Microwave Digestion–Dry Ash Preparation and Flow Injection Hydride Generation Atomic Absorption SpectrometryJournal of Food Composition and Analysis, 1999
- Nomenclature in evaluation of analytical methods including detection and quantification capabilities1Adapted from the International Union of Pure and Applied Chemistry (IUPAC) document “Nomenclature in Evaluation of Analytical Methods including Detection and Quantification Capabilities”, which originally appeared in Pure and Applied Chemistry, 67 1699–1723 (1995) © 1995 IUPAC. Republication permission granted by IUPAC.1Analytica Chimica Acta, 1999
- Determination of trace elements in shellfish tissue samples by inductively coupled plasma mass spectrometryAnalytica Chimica Acta, 1999
- Concentrations of 55 Major and Trace Elements in Danish Agricultural Crops Measured by Inductively Coupled Plasma Mass Spectrometry. 2. Pea (Pisum sativumPing Pong)Journal of Agricultural and Food Chemistry, 1998
- Extractive Spectrophotometric Determination of Selenium(IV) Using Sodium Salt of HexamethyleneiminecarbodithioateAnalytical Letters, 1995
- Determination of selenium in foodstuffs using spectrofluorometry and hydride generation atomic absorption spectrometryJournal of Food Composition and Analysis, 1992