High-Performance and Flexible Neodymium- Doped Oxide Semiconductor Thin-Film Transistors With Copper Alloy Bottom-Gate Electrode
- 5 April 2018
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 39 (6) , 839-842
Abstract
In this letter, copper alloy Cu-0.3 wt.% Cr-0.2 wt.% Zr film was used as bottom-gate electrode for flexible neodymium-doped InZnO thin-film transistor (TFT) applications. The results showed that the sputtering power and annealing temperature of a Cu-Cr-Zr film on a polyimide (PI) substrate greatly affect the resistivity and the adhesion of the gate electrode. And the lowest resistivity as well as the best adhesion was obtained by increasing power and annealing temperature to 150 W and 350°, respectively, which was compatible with the optimum annealing temperature of Nd.IZO channel. Transmission electron microscopy showed the aggregation and migration of Cr and Zr in the Cu-Cr-Zr layer, which results in a high adhesion strength and conductivity. As a result, the Nd.IZO TFT with the Cu-Cr-Zr bottom-gate electrode was fabricated on the PI substrate and demonstrated a saturation mobility (μ sat ) of 27.0 cm 2 /V · s, an ON/OFF current ratio (I ON /I OFF ) of 107, a threshold voltage (V th ) of -0.1 V, and a subthreshold swing of 0.28 V/decade (no significant deterioration after 10k times repetitive bending stress). Furthermore, it exhibited a good mechanical bending stability of only a AV th shift of -0.3/0.43 V after 10k times repetitive bending stress under negative/positive gate bias stress conditions for 5400 s.Keywords
Funding Information
- National Key R&D Program of China (2016YFB0401504)
- National Natural Science Foundation of China (51771074, U1601651)
- National Key Basic Research and Development Program of China (973 program) through MOST (2015CB655004)
- Guangdong Natural Science Foundation (2016A030313459, 2017A030310028)
- Guangdong Science and Technology Project (2016B090907001, 2016A040403037, 2017A050503002, 2016B090906002)
- Guangzhou Science and Technology Project (201804020033)
This publication has 29 references indexed in Scilit:
- An investigation of optimal interfacial film condition for Cu-Mn alloy based source/drain electrodes in hydrogenated amorphous silicon thin film transistorsAIP Advances, 2012
- Effect of Ti∕Cu Source∕Drain on an Amorphous IGZO TFT Employing SiNx Passivation for Low Data-Line ResistanceElectrochemical and Solid-State Letters, 2012
- Ti/Cu bilayer electrodes for SiNx-passivated Hf–In–Zn–O thin film transistors: Device performance and contact resistanceApplied Physics Letters, 2010
- Low-Resistivity and Adhesive Sputter-Deposited Cu–Ca Films with an Intermediate Oxide LayerJapanese Journal of Applied Physics, 2010
- P‐33: Cu‐Mn Electrodes for a‐Si TFT and Its Electrical CharacteristicsSID Symposium Digest of Technical Papers, 2010
- P‐59: Lower Resistivity Wiring Process for TFT Source/Drain Electrodes by Oxygen‐Mixture Sputtering of Cu‐Ca AlloySID Symposium Digest of Technical Papers, 2009
- High-Performance Indium Gallium Zinc Oxide Transparent Thin-Film Transistors Fabricated by Radio-Frequency SputteringJournal of the Electrochemical Society, 2008
- Cu∕CuMg Gate Electrode for the Application of Hydrogenated Amorphous Silicon Thin-Film TransistorsElectrochemical and Solid-State Letters, 2007
- Mechanics of TFT Technology on Flexible Substrates2005
- Room-temperature fabrication of transparent flexible thin-film transistors using amorphous oxide semiconductorsNature, 2004