Drug release from polymer-coated TiO2 nanotubes on additively manufactured Ti-6Al-4V bone implants: a feasibility study
Open Access
- 10 February 2021
- journal article
- research article
- Published by IOP Publishing in Nano Express
- Vol. 2 (1) , 010018
Abstract
Insufficient osseointegration, inflammatory response and bacterial infection are responsible for the majority of bone implant failures. Drug-releasing implants subjected to adequate surface modification can concurrently address these challenges to improve the success of implant surgeries. This work investigates the use of Ti-6Al-4V (Ti64) with a dual-scale surface topography as a platform for local drug delivery. Dual-scale topography was obtained combining the inherent microscale roughness of the Ti64 samples manufactured by selective laser melting (SLM) with the nanoscale roughness of TiO2 nanotubes (TNTs) obtained by subsequent electrochemical anodization at 60 V for 30 min. TNTs were loaded with a solution of penicillin-streptomycin, a common antibiotic, and drug release was tested in vitro. Three biocompatible and biodegradable polymers, i.e. chitosan, poly(ε-caprolactone) and poly(3-hydroxybutyrate), were deposited by spin coating, while preserving the microscale topography of the substrate underneath. The presence of polymer coatings overall modified the drug release pattern, as revealed by fitting of the experimental data with a power-law model. A slight extension in the overall duration of drug release (about 17% for a single layer and 33% for two layers of PCL and PHB) and reduced burst release was observed for all polymer-coated samples compared to uncoated, especially when two layers of coatings were applied.Keywords
This publication has 38 references indexed in Scilit:
- Sustained Ibuprofen Release Using Composite Poly(Lactic-co-Glycolic Acid)/Titanium Dioxide Nanotubes from Ti Implant SurfaceJournal of Pharmaceutical Sciences, 2013
- Bone response to laser-induced micro- and nano-size titanium surface featuresNanomedicine: Nanotechnology, Biology and Medicine, 2011
- TiO2 Nanotubes: Synthesis and ApplicationsAngewandte Chemie International Edition, 2011
- Controlled drug release from porous materials by plasma polymer depositionChemical Communications, 2010
- Balling phenomena in direct laser sintering of stainless steel powder: Metallurgical mechanisms and control methodsMaterials & Design (1980-2015), 2009
- Titanium dioxide nanotubes enhance bone bonding in vivoJournal of Biomedical Materials Research Part A, 2009
- 6 Studies of spin-coated polymer filmsAnnual Reports Section "C" (Physical Chemistry), 2005
- Poly(β-hydroxyalkanoates) as Potential Biomedical Materials: An Overview2001
- Understanding and controlling the bone–implant interfaceBiomaterials, 1999
- Titanium: The implant material of todayJournal of Materials Science, 1987