Effect of graphene on the interfacial and mechanical properties of hybrid glass/Kevlar fiber metal laminates
- 17 June 2020
- journal article
- research article
- Published by SAGE Publications in Journal of Industrial Textiles
- Vol. 51 (2_suppl) , 2576S-2593S
Abstract
The remarkable resurgence of fiber metal laminates (FMLs) is certainly attributed to the hybrid properties inherent to light metals and fibers reinforced polymer (FRP). There are few reports on the role of nano-size reinforcements in these composites. In this study, the effect of graphene nanoplatelets (GNPs) on the flexural and Charpy impact properties of FMLs of aluminum (Al) 2024 reinforced with hybrid glass/Kevlar fibers-epoxy was investigated. Different wt.% of GNPs (0.0, 0.1, 0.25 and 0.5) and hand lay-up method were used to fabricate nano-FMLs followed by evaluating them in three-point bend and Charpy impact tests. Before making the FMLs, the surfaces of Al sheets were modified to generate surface pores/nano-pores in order to improve the interfacial bonding within the FMLs layers. The FMLs containing 0.1 wt.% GNPs exhibited 10%, 9% and 11% improvement in flexural strength and modulus and impact strength, respectively, compared to the FMLs containing 0.0 wt.% GNPs. Increase of the GNPs to 0.25 wt.% caused a reduction of the flexural strength and modulus and impact strength values; 13.7%, 3% and 25.5% compared to the samples without GNPs. Also increase of the GNPs to 0.5 wt.% decreased these properties to 31.3%, 8.8% and 29.5%. Scanning electron microscopy (SEM) observations of their fracture surfaces showed better adhesion at both polymer/fibers (within the FRP) and Al/FRP interfaces. However, at higher wt.% of GNPs, the FMLs became weaker and more brittle. Agglomerated GNPs at the Al/FRP interface penetrated/filled the surface pores/nano-pores on the Al surfaces. Therefore prevent the polymer penetration in pores, resulting in weak interfacial bond and thus overall weaker and less ductile FMLs. As a result, the Charpy impact values for the 0.25 and 0.5 wt.% GNPs samples were respectively 33 and 37 percent smaller than that for the 0.1 wt.% GNPs sample.Keywords
This publication has 20 references indexed in Scilit:
- Preparation and characterization of graphite nano-platelet (GNP)/epoxy nano-composite: Mechanical, electrical and thermal propertiesEuropean Polymer Journal, 2013
- The effect of thermal cycles on the mechanical properties of fiber–metal laminatesMaterials & Design (1980-2015), 2012
- Graphene-based compositesChemical Society Reviews, 2011
- The effect of adding carbon nanotubes to glass/epoxy composites in the fibre sizing and/or the matrixComposites Part A: Applied Science and Manufacturing, 2010
- Mechanical properties of a novel fiber–metal laminate based on a polypropylene compositeMechanics of Materials, 2009
- Graphene-based composite materialsNature, 2006
- Electric Field Effect in Atomically Thin Carbon FilmsScience, 2004
- Influence of fiber type and wetting agent on the flexural properties of an indirect fiber reinforced compositeThe Journal of Prosthetic Dentistry, 2002
- Effect of Chemical Treatment of Kevlar Fibers on Mechanical Interfacial Properties of CompositesJournal of Colloid and Interface Science, 2002
- The Adhesion of Polymers to Metals: The Role of Surface Topography1983