Analytical Soft Error Models Accounting for Die-to-Die and Within-Die Variations in Sub-Threshold SRAM Cells
- 30 October 2009
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Very Large Scale Integration (VLSI) Systems
- Vol. 19 (2) , 182-195
Abstract
Sub-threshold SRAM cells are attractive because of their low leakage power and low access energy. However, the susceptibility of sub-threshold SRAM cells to soft errors is high due to their low supply voltage, high density, and shrinking geometry. Moreover, the increase in statistical variations in advanced nanometer CMOS technologies poses a major challenge for sub-threshold circuits designers. In this paper, analytical models for the sub-threshold SRAM critical charge variations, which account for both die-to-die (D2D) and within-die (WID) variations, are proposed. The derived models are then compared with Monte Carlo simulations by using industrial hardware-calibrated 65-nm CMOS technology. This paper also provides novel design insights such as the impact of the coupling capacitor, one of the most common soft error mitigation techniques, on the critical charge variability. In addition, it demonstrates that the relative critical charge variability is minimum at a certain temperature value. Then, the circuit designer can employ these results with temperature control techniques to minimize the critical charge variability in the early design cycles, especially, for applications with strict soft error rate (SER) constraints. In Zaddition, the proposed models show that the device sub-threshold swing coefficient can be optimized to minimize the relative critical charge variability.Keywords
This publication has 43 references indexed in Scilit:
- Static Noise Margin Variation for Sub-threshold SRAM in 65-nm CMOSIEEE Journal of Solid-State Circuits, 2006
- Alpha-particle-induced SER of embedded SRAMs affected by variations in process parameters and by the use of process optionsSolid-State Electronics, 2005
- Variation-tolerant circuits2005
- Threshold voltage mismatch and intra-die leakage current in digital CMOS circuitsIEEE Journal of Solid-State Circuits, 2004
- Leakage current mechanisms and leakage reduction techniques in deep-submicrometer CMOS circuitsProceedings of the IEEE, 2003
- Numerical evaluation of the Lambert W function and application to generation of generalized Gaussian noise with exponent 1/2IEEE Transactions on Signal Processing, 2002
- Impact of die-to-die and within-die parameter fluctuations on the maximum clock frequency distribution for gigascale integrationIEEE Journal of Solid-State Circuits, 2002
- Universal-V/sub dd/ 0.65-2.0-V 32-kB cache using a voltage-adapted timing-generation scheme and a lithographically symmetrical cellIEEE Journal of Solid-State Circuits, 2001
- Soft errors in advanced semiconductor devices-part I: the three radiation sourcesIEEE Transactions on Device and Materials Reliability, 2001
- Impact of CMOS technology scaling on the atmospheric neutron soft error rateIEEE Transactions on Nuclear Science, 2000