Effect of the Welding Filler Material on the Mechanical and Corrosive Behavior of Böhler W350 ISOBLOC Hot Forming Tool Steel
Authors:
Open Access
- 18 April 2023
- journal article
- research article
- Published by Periodica Polytechnica Budapest University of Technology and Economics in Periodica Polytechnica Mechanical Engineering
- Vol. 67 (2) , 137-142
Abstract
In this study, the effects of different welding filler materials were examined in the case of repair welding of pressure infiltration casting tool made out of Böhler W350 ISOBLOC hot forming tool steel. Three additional welding filler materials were used: Böhler W350 ISOBLOC (same as the raw material), Böhler W300 ISOBLOC and Anviloy® 1150 tungsten alloy. The welds were created with TIG welding method. The used welding filler material has an impact on the mechanical and corrosive properties of the tool. The hardness of the weld was measured to determine its resistance against mechanical stress. The corrosion rate was measured because molten aluminium corrodes workpieces due to its high chemical activity. It was concluded that a single-pass weld corrosion speed is 0.142 ± 0.010 mm/year while a weld containing multiple layers and passes has the corrosion speed of 0.069 ± 0.005 mm/year which is approximately 48% of the corrosion speed of the single-pass weld. Furthermore, the hardness of a weld made with W350 welding filler material significantly drops in the upper layers of the weld, down to 273 HV1 while the hardness of the base material is 495 ± 8 HV1. The results show that the multiple layers and passes welds have better corrosion resistance and less hardness than the single-pass weld.Keywords
This publication has 14 references indexed in Scilit:
- Optimization of machining process parameters of high pressure die casting for improve the quality of manufactured productMaterials Today: Proceedings, 2022
- Effects of welding wire composition on the repair welds of sand-cast Mg–Gd–Y alloy: Microstructure and mechanical propertiesVacuum, 2022
- The microstructure and tensile properties of additively manufactured Ti–6Al–2Zr–1Mo–1V with a trimodal microstructure obtained by multiple annealing heat treatmentMaterials Science and Engineering: A, 2022
- Influence of Cr on the interfacial boride reaction between Fe-Cr-B cast steel and molten aluminiumCorrosion Science, 2019
- Interface morphology and corrosion behavior of bulk Fe2B in liquid AlMaterials Characterization, 2019
- Corrosion test of overlapping coronary artery stents made of different materialsMaterials Today: Proceedings, 2018
- Influence of the Cooling Rate on the Microstructure and Mechanical Properties in 5% Cr Martensitic SteelBHM Berg- und Hüttenmännische Monatshefte, 2017
- Gas metal arc welding of dissimilar AHSS sheetsMaterials & Design, 2016
- Corrosion Mechanisms of Steel and Cast Iron by Molten AluminumMetallurgical and Materials Transactions A, 2010
- Production Techniques 2 Shell, investment and die casting processes2001