Effect of aging and mechanical brushing on surface roughness of 3D printed denture resins: A profilometer and scanning electron microscopy analysis
Authors:
- 29 December 2021
- journal article
- research article
- Published by SAGE Publications in Technology and Health Care
- Vol. 30 (1) , 161-173
Abstract
BACKGROUND: The use of 3D printed material in the dental field is gaining tremendous attention. However, studies related to 3D printed denture resins are scarce and need consideration before their inclusion in routine clinical practice. OBJECTIVE: This study aimed to assess the surface roughness (Ra) of 3D printed denture resins following aging and mechanical brushing. METHODS: Forty round samples (diameter, 10 mm and thickness, 3 mm) were fabricated from two 3D printed (DentaBASE and Denture 3D+) and one conventional polymethylmethacrylate (PMMA) denture materials. The samples were thermo-cycled, subjected to mechanical brushing, and later immersed in either artificial saliva (AS), coffee, cola, or lemon juice (n= 10) to simulate one and two years of oral use. Surface roughness (Ra) was determined using a non-contact profilometer and scanning electron microscope was used for qualitative analysis. The data was analyzed using SPSS v.20 (α= 0.05). RESULTS: Denture 3D+ demonstrated highest mean Ra (1.15 ± 0.28 μm), followed by PMMA (0.99 ± 0.50 μm) and DentaBASE (0.81 ± 24). The difference in mean Ra between the materials was statistically non-significant (P= 0.08). Amongst the different beverages used, the highest Ra was observed for samples immersed in lemon juice (1.06 ± 0.40 μm) followed by cola (1.04 ± 0.46 μm) and coffee (0.98 ± 0.40 μm), respectively. The lowest Ra was observed for samples immersed in AS (0.85 ± 0.24 μm). CONCLUSION: The surface roughness of 3D printed denture resins was comparable with that of conventional PMMA resins. Denture 3D+ demonstrated the highest mean roughness, followed by PMMA and DentaBASE.Keywords
This publication has 36 references indexed in Scilit:
- The Impact of Edentulism on Oral and General HealthInternational Journal of Dentistry, 2013
- Comparative evaluation of surface porosities in conventional heat polymerized acrylic resin cured by water bath and microwave energy with microwavable acrylic resin cured by microwave energyContemporary Clinical Dentistry, 2013
- Weight loss and changes in surface roughness of denture base and reline materials after simulated toothbrushing in vitroGerodontology, 2011
- Color Stability of Denture Acrylic Resins and a Soft Lining Material Against Tea, Coffee, and NicotineJournal of Prosthodontics, 2010
- Acidic beverages increase the risk of in vitro tooth erosionNutrition Research, 2008
- The Effect of Aging by Thermal Cycling and Mechanical Brushing on Resilient Denture Liner Hardness and RoughnessJournal of Prosthodontics, 2008
- Surface Roughness of Denture Base Acrylic Resins After Processing and After PolishingJournal of Prosthodontics, 2006
- The in vivo perception of roughness of restorationsBritish Dental Journal, 2004
- The influence of surface roughness and surface‐free energy on supra‐ and subgingival plaque formation in manJournal of Clinical Periodontology, 1995
- Fluoride Taken Up by Plaque, by the Underlying Enamel and by Clean Enamel from Three Fluoride Compounds in vitroCaries Research, 1982