Which factors prognosticate rotational instability following lumbar laminectomy?
- 17 September 2013
- journal article
- research article
- Published by Springer Nature in European Spine Journal
- Vol. 22 (12) , 2897-2903
Abstract
Purpose Reduced strength and stiffness of lumbar spinal motion segments following laminectomy may lead to instability. Factors that predict shear biomechanical properties of the lumbar spine were previously published. The purpose of the present study was to predict spinal torsion biomechanical properties with and without laminectomy from a total of 21 imaging parameters. Method Radiographs and MRI of ten human cadaveric lumbar spines (mean age 75.5, range 59–88 years) were obtained to quantify geometry and degeneration of the motion segments. Additionally, dual X-ray absorptiometry (DXA) scans were performed to measure bone mineral content and density. Facet-sparing lumbar laminectomy was performed either on L2 or L4. Spinal motion segments were dissected (L2–L3 and L4–L5) and tested in torsion, under 1,600 N axial compression. Torsion moment to failure (TMF), early torsion stiffness (ETS, at 20–40 % TMF) and late torsion stiffness (LTS, at 60–80 % TMF) were determined and bivariate correlations with all parameters were established. For dichotomized parameters, independent-sample t tests were used. Results Univariate analyses showed that a range of geometric characteristics and disc and bone quality parameters were associated with torsion biomechanical properties of lumbar segments. Multivariate models showed that ETS, LTS and TMF could be predicted for segments without laminectomy (r 2 values 0.693, 0.610 and 0.452, respectively) and with laminectomy (r 2 values 0.952, 0.871 and 0.932, respectively), with DXA-derived measures of bone quality and quantity as the main predictors. Conclusions Vertebral bone content and geometry, i.e. intervertebral disc width, frontal area and facet joint tropism, were found to be strong predictors of ETS, LTS and TMF following laminectomy, suggesting that these variables could predict the possible development of post-operative rotational instability following lumbar laminectomy. Proposed diagnostic parameters might aid surgical decision-making when deciding upon the use of instrumentation techniques.Keywords
This publication has 28 references indexed in Scilit:
- Which factors prognosticate spinal instability following lumbar laminectomy?European Spine Journal, 2012
- The impact of bone mineral density and disc degeneration on shear strength and stiffness of the lumbar spine following laminectomyEuropean Spine Journal, 2011
- Anterior shear strength of the porcine lumbar spine after laminectomy and partial facetectomyEuropean Spine Journal, 2010
- Modified Pfirrmann Grading System for Lumbar Intervertebral Disc DegenerationSpine, 2007
- A biomechanical analysis of the self-retaining pedicle hook device in posterior spinal fixationEuropean Spine Journal, 2007
- Fatigue Failure in Shear Loading of Porcine Lumbar Spine SegmentsSpine, 2006
- Validity and interobserver agreement of a new radiographic grading system for intervertebral disc degeneration: Part I. Lumbar spineEuropean Spine Journal, 2005
- Review of existing grading systems for cervical or lumbar disc and facet joint degenerationEuropean Spine Journal, 2005
- Foot positioning instruction, initial vertical load position and lifting technique: effects on low back loadingErgonomics, 2004
- The Torsional Injury of the Lumbar SpineSpine, 1984