Obtaining reliable transient rheological data on concentrated short fiber suspensions using a rotational rheometer
Authors:
- 1 September 2009
- journal article
- Published by Society of Rheology in Journal of Rheology
- Vol. 53 (5) , 1049-1068
Abstract
The conventional method for obtaining transient rheological data on short glass fiber-filled polymeric fluids is to use the parallel disk (PP) geometry in a rotational rheometer. Using the PP geometry large transient stress overshoot behavior was observed during the startup of flow measurements on a 30 wt % short glass fiber-filled polybutylene terephthalate. A contributing factor to this behavior is believed to be induced fiber collisions caused by the inhomogeneous velocity field (radial varying velocity gradient). A novel approach was taken in which a “donut” shaped sample was used in a cone-and-plate device (CP-D) to maintain a sufficient gap to fiber length ratio. The magnitude of the first normal stress difference was reduced by 70%, and the time to reach steady state was reduced by 100 strain units. The Lipscomb model coupled with the Folgar–Tucker model for the evolution of fiber orientation was fit to the stress growth behavior measured using both the PP geometry and CP-D resulting in different parameters. In addition, the fitted model parameters were found to depend on the initial fiber orientation. It is believed that the CP-D allows for an accurate determination of the stress growth behavior and eventually will allow one to obtain unambiguous model parameters.Keywords
This publication has 32 references indexed in Scilit:
- Rheology of Non-Newtonian Fluids Containing Glass Fibers: A Review of Experimental LiteratureIndustrial & Engineering Chemistry Research, 2008
- The Dynamic Behavior of a Concentrated Non-Brownian Glass Fiber Suspension in Simple Shear FlowAIP Conference Proceedings, 2008
- Study of geometry effects in torsional rheometry of fibre suspensionsRheologica Acta, 2004
- Studies on thermal and thermo-oxidative degradation of poly(ethylene terephthalate) and poly(butylene terephthalate)Polymer Degradation and Stability, 2001
- Fiber motion and rheology of suspensions with uniform fiber orientationJournal of Polymer Science Part B: Polymer Physics, 2000
- Stereological measurement and error estimates for three‐dimensional fiber orientationPolymer Engineering & Science, 1992
- The Use of Tensors to Describe and Predict Fiber Orientation in Short Fiber CompositesJournal of Rheology, 1987
- A Rheological Equation of State for Semiconcentrated Fiber SuspensionsJournal of Rheology, 1984
- A Fundamental Study of the Rheological Properties of Glass‐Fiber‐Reinforced Polyethylene and Polystyrene MeltsJournal of Rheology, 1978
- The viscosity of suspensions of straight, rigid rodsJournal of Colloid and Interface Science, 1966