Direct measurements of laser absorptivity during metal melt pool formation associated with powder bed fusion additive manufacturing processes
Authors:
- 13 June 2018
- journal article
- conference paper
- Published by Laser Institute of America in Journal of Laser Applications
- Vol. 30 (3) , 032302
Abstract
Direct calorimetric measurements are used to study the effective optical absorptivity at 1070 nm laser wavelength for bulk and powder-coated discs of industrially relevant metals. Effective absorptivity is plotted as a function of nominal laser power from 30 up to 600 W for scanning velocities of 100, 500, and 1500 mm/s. The absorptivity versus power curves of the bulk materials typically shows a reduction in effective absorptivity until the beginning of the formation of a keyhole-type surface depression that is associated with an increased absorption of the laser light in the growing keyhole until a saturation value is reached. For powders, an additional plateau of higher absorptivity can be observed for low laser power, until the curves qualitatively collapse when full melting of the powder tracks is achieved. It is shown that, under conditions associated with laser powder-bed fusion additive manufacturing, absorptivity values can vary greatly, and differ from both room temperature powder layer measurements and liquid metal estimates from the literature.Keywords
This publication has 13 references indexed in Scilit:
- Metal powder absorptivity: modeling and experimentApplied Optics, 2016
- Denudation of metal powder layers in laser powder bed fusion processesActa Materialia, 2016
- Laser powder-bed fusion additive manufacturing: Physics of complex melt flow and formation mechanisms of pores, spatter, and denudation zonesActa Materialia, 2016
- Overview of modelling and simulation of metal powder bed fusion process at Lawrence Livermore National LaboratoryMaterials Science and Technology, 2015
- Temperature-dependent 780-nm laser absorption by engineering grade aluminum, titanium, and steel alloy surfacesOptical Engineering, 2014
- Factor analysis of selective laser melting process parameters and geometrical characteristics of synthesized single tracksRapid Prototyping Journal, 2012
- The absorption of light by rough metal surfaces—A three-dimensional ray-tracing analysisJournal of Applied Physics, 2008
- Absorptance of powder materials suitable for laser sinteringRapid Prototyping Journal, 2000
- Energy Coupling Efficiency in Laser Surface Treatment.ISIJ International, 1993
- Optical constants and spectral selectivity of stainless steel and its oxidesJournal of Applied Physics, 1982