Microstructure and Wear Performance of High-Velocity Arc Sprayed FeMnCrNiBNbAl Coating
Open Access
Abstract
In this study, FeMnCrNiBNbAl wear-resistant coatings were prepared via high-velocity arc spraying technology on the surface of Q235 steel. The effects of spraying distance, voltage, and current on the coating performance were studied via the orthogonal experimental method with microhardness and porosity as evaluation indicators, and the process parameters were optimized. The order of primary and secondary factors affecting coating performance were: spraying distance, voltage, and current. The optimized process parameters are: spraying distance 200 mm, voltage 36 V, and current 240 A. The coating prepared using the optimized process parameters has an average microhardness of 756 HV0.1 and an average porosity of 1.03%. The coating mainly consists of α-Fe, Fe-Cr, Ni-Cr-Fe, Al2O3, and (Fe, Ni) solid solution. The coating friction coefficient was 0.5 while that of the substrate was 0.7. The depth and width of the wear marks of the coating were 6.32 µm and 555.41 µm, respectively, which are 66% and 32% lower in comparison with Q235 steel under the same test conditions. The wear forms of this coating were mainly fatigue peeling and adhesive wear.Keywords
Funding Information
- Jiangsu Provincial key research and development plan (No. BE2020311)
This publication has 30 references indexed in Scilit:
- Effects of Annealing Treatment on Corrosion Resistance of Arc Sprayed Aluminum CoatingJournal of Thermal Spray Technology, 2022
- Microstructure and Tribological Properties of Fe-Based Composite Coatings Prepared by High-Velocity Arc SprayingJournal of Thermal Spray Technology, 2022
- Microstructure and Wear Properties of TiB2 Reinforced Fe-Based Composite CoatingJournal of Materials Engineering and Performance, 2022
- Cavitation Erosion Resistance of Fe-Based Amorphous/Nanocrystal Coatings Prepared by High-Velocity Arc SprayingJournal of Thermal Spray Technology, 2014
- Arc-Sprayed Iron-Based Coatings for Erosion-Corrosion Protection of Boiler Tubes at Elevated TemperaturesJournal of Thermal Spray Technology, 2013
- Research on automatic high velocity arc spraying technique and metastable coating materialsAdvances in Manufacturing, 2013
- Microstructure and Mechanical Properties of FeBSiNb Metallic Glass Coatings by Twin Wire Arc SprayingJournal of Thermal Spray Technology, 2013
- Wear and Corrosion Behaviors of FeCrBSiNbW Amorphous/Nanocrystalline Coating Prepared by Arc Spraying ProcessJournal of Thermal Spray Technology, 2012
- Effects of Arc Spray Process Parameters on Corrosion Resistance of Ti CoatingsJournal of Thermal Spray Technology, 2009
- Correlation of Microstructure with Hardness, Wear Resistance, and Corrosion Resistance of Powder-Injection-Molded Specimens of Fe-Alloy PowdersMetallurgical and Materials Transactions A, 2009