Structure and properties of a cobalt-chromium-molybdenum alloy obtained by selective laser melting
Open Access
- 1 February 2021
- conference paper
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 1100 (1) , 012055
Abstract
Cobalt-based heat-resistant alloys have unique properties that are used in corrosive environments and at high temperatures. The addition of chromium improves resistance to hot corrosion, while molybdenum improves corrosion resistance and strength. When machining a workpiece of a heat-resistant alloy, up to half of the material goes into chips and goes to processing. Modern trends in the development of additive technologies are aimed at saving material, introducing new materials and improving the physical and mechanical characteristics of the resulting products. Selective laser melting (SLM) is one of the additive methods for obtaining bulk metal products and is one of the most promising directions in the development of science and technology in recent years. This paper describes the porosity (the average value was 14 ± 5%), the structure and properties of alloy samples obtained by selective laser melting in the following modes: laser power - 100 W, scanning speed - 350 mm / s, thickness of the applied powder layer - 25 um, scanning step - 100 um, frequency of pulse-periodic laser action (modulations) - 2.5 kHz from a spherical powder of the CoCrMo alloy (66 wt% Co, 28 wt% Cr, 6 wt% Mo).Keywords
This publication has 11 references indexed in Scilit:
- Tuning strain-induced γ-to-ε martensitic transformation of biomedical Co–Cr–Mo alloys by introducing parent phase lattice defectsJournal of the Mechanical Behavior of Biomedical Materials, 2019
- An investigation into the aging behavior of CoCrMo alloys fabricated by selective laser meltingJournal of Alloys and Compounds, 2018
- Effect of Cu on microstructure, mechanical properties, corrosion resistance and cytotoxicity of CoCrW alloy fabricated by selective laser meltingJournal of the Mechanical Behavior of Biomedical Materials, 2018
- Mechanical and phase transformation behaviour of biomedical Co-Cr-Mo alloy fabricated by direct metal laser sinteringMaterials Science and Engineering: A, 2018
- Structural and Phase State of Ti–Nb Alloy at Selective Laser Melting of the Composite PowderRussian Physics Journal, 2016
- Effects of carbide precipitation on the microstructural and tribological properties of Co–Cr–Mo–C medical implants after thermal treatmentJournal of Materials Science, 2016
- Textures formed in a CoCrMo alloy by selective laser meltingJournal of Alloys and Compounds, 2015
- Structural characterization of biomedical Co–Cr–Mo components produced by direct metal laser sinteringMaterials Science and Engineering: C, 2015
- Selective laser sintering/melting of nitinol–hydroxyapatite composite for medical applicationsPowder Metallurgy and Metal Ceramics, 2011
- Solid free-form fabrication of drug delivery devicesJournal of Controlled Release, 1996