Turning modeling and simulation of an aerospace grade aluminum alloy using two-dimensional and three-dimensional finite element method
- 1 October 2013
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture
- Vol. 228 (3) , 367-375
Abstract
This article presents the development of two-dimensional and three-dimensional finite element–based turning models, for better prediction of chip morphology and machined surface topology. Capabilities of a commercial finite element code Abaqus®/Explicit have been exploited to perform coupled temperature–displacement simulations of an aerospace grade aluminum alloy A2024-T351 machining. The findings show that two-dimensional cutting models predict chip morphologies and machined surface textures on a plane section (with unit thickness) passing through the center of workpiece width, and not at the edges. The contribution highlights the importance of three-dimensional machining models for a close corroboration of experimental and numerical results. Three-dimensional cutting simulations show that a small percentage of material volume flows toward workpiece edges (out of plane deformation), augmenting the contact pressures at the edges of tool rake face–workpiece interface. This enhances the burr formation process. Computational results concerning chip morphologies and cutting forces were found in good correlation with experimental ones. In the final part of the article, numerical simulation results with a modified version of a particular turning tool have been discussed. It has been found that the proposed geometry of the tool is helpful in reducing burr formation as well as cutting force amplitude during initial contact of cutting tool with the workpiece material.Keywords
This publication has 21 references indexed in Scilit:
- Finite-element-based hybrid dynamic cutting model for aluminium alloy millingProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2009
- Numerical and experimental study of dry cutting for an aeronautic aluminium alloy (A2024-T351)International Journal of Machine Tools and Manufacture, 2008
- Numerical modelling of orthogonal cutting: influence of numerical parametersJournal of Materials Processing Technology, 2005
- Estimation of tool wear in orthogonal cutting using the finite element analysisJournal of Materials Processing Technology, 2004
- A finite element analysis of orthogonal machining using different tool edge geometriesJournal of Materials Processing Technology, 2004
- Development of a drilling burr control chart for low alloy steel, AISI 4118Journal of Materials Processing Technology, 2001
- Turning simulations using a three-dimensional FEM codeJournal of Materials Processing Technology, 2000
- Determination of workpiece flow stress and friction at the chip–tool contact for high-speed cuttingInternational Journal of Machine Tools and Manufacture, 2000
- A Study of Burr Formation Processes Using the Finite Element Method: Part IJournal of Engineering Materials and Technology, 1999
- A Numerical Method for Determining Temperature Distributions in Machining with Coolant: Part 1: Modelling the ProcessProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 1995