Dry sliding wear characteristics ofin situsynthesized Al-TiC composites
Authors:
- 19 February 2016
- journal article
- research article
- Published by Taylor & Francis in Composite Interfaces
- Vol. 23 (6) , 469-480
Abstract
Aluminum-based composites containing 0.06, 0.09, 0.12 fractions of in situ-synthesized TiC (Titanium carbide) particles have been prepared through in-melt reaction from Ai–SiC–Ti system following a simple and cost-effective stir-casting route. The TiC forms by the reaction of Ti with carbon which is released by SiC at temperatures greater than 1073 K. However, some amount of titanium aluminide (Al3Ti) is also formed. The formation of TiC has been confirmed through X-ray diffraction studies of the composite. The hardness and tensile strength have been found to increase with increasing amount of TiC. The friction and wear characteristics of the composites have been determined by carrying out dry sliding tests on pin-on-disc machine at different loads of 9.8 N, 19.6 N, 29.4 N, 39.2 N at a constant sliding speed of the 1 m/s speed. The wear rate i.e. volume loss per unit sliding distance has been found to increase linearly with increasing load following Archard’s law. However, both the wear rate and friction coefficient have been observed to decrease with increasing amount of TiC in the composite. This has been attributed to (i) a relatively higher hardness of composites containing relatively higher amount of TiC resulting in a relatively lower real area of contact and (ii) the formation of a well-compacted mechanically mixed layer of compacted wear debris on the worn surface which might have inhibited metal–metal contact and resulted in a lower wear rate as well as friction coefficient.Keywords
This publication has 16 references indexed in Scilit:
- Sliding wear behavior of in situ Al–4.5Cu–5TiB2 composite processed by single and multiple roll passes in mushy stateWear, 2011
- Microstructure and abrasive wear behaviour of B4C particle reinforced 2014 Al matrix compositesJournal of Materials Science, 2010
- High temperature wear behavior of Al–4Cu–TiB2 in situ compositesWear, 2010
- Synthesis and tribological characterization of in situ cast Al–TiC compositesWear, 2005
- Combustion synthesis of ternary carbide Ti3AlC2 in Ti–Al–C systemJournal of the European Ceramic Society, 2003
- The effect of a dilution agent on the dipping exothermic reaction process for fabricating a high-volume TiC-reinforced aluminum compositeScripta Materialia, 2003
- Microstructural and mechanical characteristics of in situ metal matrix compositesMaterials Science and Engineering: R: Reports, 2000
- Fatigue behavior of a 2XXX series aluminum alloy reinforced with 15 vol Pct SiCpMetallurgical Transactions A, 1991
- Processing techniques for particulate-reinforced metal aluminium matrix compositesJournal of Materials Science, 1991
- Wear of two-phase metalsWear, 1977