An Active Voltage Stabilizer for a DC Microgrid System
Open Access
- 16 June 2021
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 9, 86786-86800
Abstract
This paper analyzes the low-frequency stability challenges that exist in a complex DC microgrid (MG) system. The converters that belong to a DC MG are categorized into different groups based on their control approach. The small-signal model of the DC MG is presented, and the conditions for system stability are derived. In some DC MG applications, there is the possibility of installing off-the-shelf converters with little flexibility and access for controller auto-tuning. To tackle this, a hardware-based active voltage stabilizer solution is proposed to stabilize the DC MG. The active stabilizer’s functionality, based on an isolated bidirectional DC-DC converter, is elucidated, and a suitable control strategy is proposed. The active stabilizer and its associated control configuration involve only local voltage sensing and are non-intrusive. A dual active bridge (DAB) converter-based active stabilizer is implemented, and hardware-based steady-state and transient experimental results from a DC MG test-bench are provided to validate the functionality and effectiveness of the proposed active stabilizer.Keywords
This publication has 37 references indexed in Scilit:
- Stability Analysis and Dynamic Performance Evaluation of a Power Electronics-Based DC Distribution System With Active StabilizerIEEE Journal of Emerging and Selected Topics in Power Electronics, 2015
- Impedance-Based Local Stability Criterion for DC Distributed Power SystemsIEEE Transactions on Circuits and Systems I: Regular Papers, 2015
- Modeling and Stability Analysis of Islanded DC Microgrids Under Droop ControlIEEE Transactions on Power Electronics, 2014
- Improving the Performance of a Line Regulating Converter in a Converter-Dominated DC Microgrid SystemIEEE Transactions on Smart Grid, 2014
- Comprehensive Review of Stability Criteria for DC Power Distribution SystemsIEEE Transactions on Industry Applications, 2014
- Use of unterminated two-port modeling technique in analysis of input filter interactions in telecom DPS systems2003
- Impedance specifications for stable DC distributed power systemsIEEE Transactions on Power Electronics, 2002
- A method of defining the load impedance specification for a stable distributed power systemIEEE Transactions on Power Electronics, 1995
- Performance characterization of a high-power dual active bridge DC-to-DC converterIEEE Transactions on Industry Applications, 1992
- A three-phase soft-switched high-power-density DC/DC converter for high-power applicationsIEEE Transactions on Industry Applications, 1991