Copper Nanofilm Formation by Electrochemical Atomic Layer Deposition
- 1 January 2007
- journal article
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 154 (4) , D260-D266
Abstract
Au(111) single-crystal substrates were used in studies of Cu nanofilm formation by electrochemical atomic layer deposion (ALD). Cu undepotential deposition (UPD) was used to deposit the first Cu atomic layer on a Au(111) substrate, modified with an atomic layer of I atoms. By definition, Cu UPD results in the formation of an atomic layer, thus, to deposit subsequent Cu, surface-limited redox replacement (SLRR) was used. The SLRR involved initial formation of Pb UPD on the Cu-coated surface just described. This Pb UPD-coated surface was then exposed to CuSO4CuSO4 at open-circuit potential (OCP), where the Pb atoms were exchanged for Cu. In the ultrahigh-vacuum electrochemical (UHV-EC) studies presented here, two Pb UPD potentials were investigated: −0.400−0.400 and −0.440V−0.440V . UHV-EC studies involved use of a surface analysis instrument with optics for low-energy electron diffraction and Auger, and to which was attached an ante-chamber containing a Pyrex glass electrochemical H-cell. In this way, surface analysis was performed without transfer of the deposit through air and the contamination which would result. In addition, studies of the first few cycles of redox replacement were investigated using electrochemical in situ scanning tunnel microscopy (STM), with a flow cell for solution exchange to prevent loss of potential control.Keywords
This publication has 16 references indexed in Scilit:
- Platinum Nanofilm Formation by EC-ALE via Redox Replacement of UPD Copper: Studies Using in-Situ Scanning Tunneling MicroscopyThe Journal of Physical Chemistry B, 2006
- Epitaxial Growth by Monolayer-Restricted Galvanic DisplacementElectrochemical and Solid-State Letters, 2005
- Underpotential deposition of Cu on iodine-modified Au(111): an in situ scanning tunneling microscopy studySurface Science, 2001
- Metal monolayer deposition by replacement of metal adlayers on electrode surfacesSurface Science, 2001
- The Initial Stages of Cu Deposition on Au(100) as Studied by in situ STM: The Epitaxial Growth of bcc Cu*Zeitschrift für Physikalische Chemie, 1999
- Adlayer Structures of Chlorine, Bromine, and Iodine on Cu(111) Electrode in Solution: In-Situ STM and ex-Situ LEED StudiesThe Journal of Physical Chemistry B, 1998
- Electrochemical Deposition of Copper on a Gold Electrode in Sulfuric Acid: Resolution of the Interfacial StructurePhysical Review Letters, 1995
- Ordering of Copper Single‐Crystal Surfaces in Solution: Confirmation by Low Energy Electron DiffractionJournal of the Electrochemical Society, 1990
- In situ restoration of atomically well-ordered copper single-crystal electrode surfacesJournal of the American Chemical Society, 1989
- Electrodeposition of silver onto platinum(100) surfaces containing iodineadlattices. Studies by low-energy electron diffraction, Auger spectroscopy, and thermal desorptionThe Journal of Physical Chemistry, 1984