Synthesis of Styrofoam Fibers Using Rotary Forcespinning Technique
- 1 August 2015
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 827, 279-284
Abstract
Development of rotary forcespinning (RF) to synthesize fibers has been done. High speed motor driven centrifugal force becomes a major factor in the formation of fibers. RF apparatus consists of three main parts namely the motor system, the collector, and the heating system that serves to regulate the temperature and humidity around the motor. The liquid polymer was poured in the motor holder and rotated at high speed so that the liquid was dropped from the tip of the needle to the collector in the form of fibers. In this study, the liquid polymer was from waste polystyrene foam (styrofoam) soaked in acetone at a certain ratio. The observation was done with the digital microscope up to 1000 times of magnification. The produced styrofoam fibers were similar to homogeneous and smooth cotton with an average fiber diameter in micrometer. The utilization of waste styrofoam into the fibers is expected to reduce the environmental problems caused by waste styrofoam.Keywords
This publication has 18 references indexed in Scilit:
- Parameter study and characterization for polyacrylonitrile nanofibers fabricated via centrifugal spinning processEuropean Polymer Journal, 2013
- Fabrication of nanofiber meltblown membranes and their filtration propertiesJournal of Membrane Science, 2013
- Experimental research on thermo-direct fiber drawing techniqueMicroelectronic Engineering, 2011
- Morphology Controlled Electrospun Nanofibers for Humidity Sensor ApplicationAIP Conference Proceedings, 2011
- Morphology optimization of polymer nanofiber for applications in aerosol particle filtrationSeparation and Purification Technology, 2010
- Indium Tin Oxide Nanofiber Film Electrode for High Performance Dye Sensitized Solar CellsJapanese Journal of Applied Physics, 2010
- Use of electrospinning technique for biomedical applicationsPolymer, 2008
- Melt blown nanofibers: Fiber diameter distributions and onset of fiber breakupPolymer, 2007
- An Introduction to Electrospinning and Nanofibers2005
- The effect of processing variables on the morphology of electrospun nanofibers and textilesPolymer, 2001