Topographic Characterization of Progressive Wear on Deep Drawing Dies
Authors:
- 1 January 1997
- journal article
- research article
- Published by Taylor & Francis in Tribology Transactions
- Vol. 40 (2) , 346-352
Abstract
The subject of this paper is an analysis of progressive, wear and other surface alteration processes which take place on deep drawing dies. The deep drawing process was simulated using strip test evaluation equipment. A theory on the influence of different surface alterations on the die surface topography was then, developed. The wear progress was quantified using conventional surface roughness parameters as well as a set of recently developed parameters based on the bearing curve and extended to thee dimensions. It was concluded from conventional surface roughness measurements that maximum wear takes place at angles of 20° and 70° from the vertical direction on the die. Furthermore, it was observed from three-dimensional measurements that the progressive wear is initialed by ploughing after only a few drawings and this mechanism continues until the die is worn out. In the investigations described in this work, the wear progress was interpreted using the. three-dimensional parameters Spk and Svk in terms of an initial ploughing stage followed by a second stage during which ploughing and abrasive wear occur simultaneously.Keywords
This publication has 1 reference indexed in Scilit:
- A digital system for surface roughness analysis of plane and cylindrical partsPrecision Engineering, 1987