On the Microstructure of XW-42 Steel after Direct Partial Remelting
- 1 October 2010
- journal article
- Published by Trans Tech Publications, Ltd. in Advanced Materials Research
- Vol. 154-155, 1280-1283
Abstract
In order to be considered as a material for semi-solid processing, an alloy has to possess solid spheroids within liquid matrix. Therefore, it is important to investigate the structure of the candidate alloy prior to forming process by conducting partial melting experiment. In this research, the partial melting was conducted for XW-42 steel directly from as annealed condition without any pre-treatment (Direct Partial Remelting). Liquid Fraction Profile obtained from Differential Thermal Analysis (DTA) showed that temperature of 1340°C was located in a low temperature sensitivity region, hence making it as a candidate for processing temperature. Direct Partial Remelting at this temperature for 0, 2 and 5 minutes revealed near spheroidal structure with average grain size between between 45-51 µm which can be considered suitable for semi-solid processing.Keywords
This publication has 5 references indexed in Scilit:
- Solid–liquid structural break-up in M2 tool steel for semi-solid metal processingJournal of Materials Science, 2009
- Robustness of a Thixoforming Production LineSolid State Phenomena, 2008
- Semi-Solid Metal Processing – A Process Looking for a MarketSolid State Phenomena, 2008
- Semi-solid thermal transformations of Al−Si alloys and the resulting mechanical propertiesMaterials Science and Engineering: A, 1997
- Rheological behavior of Sn-15 pct Pb in the crystallization rangeMetallurgical Transactions, 1972