Mechanical anisotropy in Ca-treated and ultra-low sulphur HSLA-100 steel
Authors:
- 20 January 2016
- journal article
- research article
- Published by SAGE Publications in Materials Science and Technology
- Vol. 32 (10) , 976-984
Abstract
A few elongated MnS inclusions were observed in ultra-low sulphur HSLA-100 steel which significantly decreased the yield strength (YS), ultimate tensile strength and notch toughness of short transverse direction. The slight anisotropies of YS (≈5 MPa) and notch toughness (≈15 J) between longitudinal and transverse directions are correlated to the presence of texture components in the vicinity of {113} and {554}. In the case of anisotropy between longitudinal and short transverse directions, it is found that recognising the contribution of each effective factor in the creation of strength anisotropy is not possible. However, the most primary effective factor in the creation of remarkable notch toughness anisotropy (≈70 Pct), especially at −85°C, is related to the existence of elongated MnS inclusions.Keywords
This publication has 32 references indexed in Scilit:
- Effect of direct quenching on the microstructure and mechanical properties of the lean-chemistry HSLA-100 steel platesMaterials Science and Engineering: A, 2011
- Impact of mechanical anisotropy on the geometry of flat-rolled fully pearlitic steel wiresJournal of Materials Processing Technology, 2011
- Texture Dependent Mechanical Anisotropy of X80 Pipeline SteelAdvanced Engineering Materials, 2010
- Effect of heat-input on austenite grain size in the heat-affected zone of HSLA-100 steelMaterials Science and Engineering: A, 2007
- Effect of cooling rate on structure and properties of an ultra-low carbon HSLA-100 grade steelMaterials Characterization, 2006
- Characterization of precipitates in an ultra low carbon Cu bearing high strength steel: A TEM studyMaterials Characterization, 2005
- Effect of tempering temperatures on the mechanical properties and microstructures of HSLA-100 type copper-bearing steelsMaterials Science and Engineering: A, 2001
- Development and Certification of HSLA ‐100 Steel for Naval Ship ConstructionNaval Engineers Journal, 1990
- Anisotropy of the charpy impact value of carbon steels and corrective heat treatmentJournal of Materials Processing Technology, 1982
- The influence of property anisotropy on the technological effectiveness of weldable steelsChemical and Petroleum Engineering, 1980