Experimental and Numerical Study of Flat Plate Sludge Drying at Low Temperature by Convection and Direct Conduction
Authors:
- 16 May 2014
- journal article
- research article
- Published by Taylor & Francis in Drying Technology
- Vol. 32 (14) , 1664-1674
Abstract
This article deals with the drying of the waste by-product of an activated sludge manure treatment plant. The studies concern the low temperature drying of planar plates 3 cm thick. The upper face of the sludge is subjected to a tangential air flow controlled for speed, temperature, and humidity. The lower face can be subjected to contact heating. The maximum temperature for air and the bottom of the product is 60 °C. After characterizing the main thermophysical and hygric properties of the product, the laboratory set-up specifically designed for this study is described. Experiments are performed to determine temperature, mass loss, and deformation evolutions for different boundary conditions. These experimental data are used to build a numerical one-dimensional heat and mass transfer model to predict temperature and moisture content fields. Sludge is assimilated with a hygroscopic porous medium, and shrinkage is not taken into account. To validate this model, several comparisons between simulated and measured data are made for different drying methods (hot or fresh air convective drying, contact drying, and combined drying) and various drying conditions.Keywords
This publication has 25 references indexed in Scilit:
- Modeling and Simulation of Heat and Mass Transfer During Convective Drying of Wastewater Sludge with Introduction of Shrinkage PhenomenaDrying Technology, 2013
- Review on fundamental aspect of application of drying process to wastewater sludgeRenewable and Sustainable Energy Reviews, 2013
- Solar drying of wastewater sludge: A reviewRenewable and Sustainable Energy Reviews, 2012
- Heat pump assisted drying of agricultural produce—an overviewJournal of Food Science and Technology, 2011
- Modeling of a solar and heat pump sludge drying systemInternational Journal of Refrigeration, 2008
- Convective Drying of Wastewater Sludges: Influence of Air Temperature, Superficial Velocity, and Humidity on the KineticsDrying Technology, 2005
- A modular approach to study the performance of a two-stage heat pump system for dryingApplied Thermal Engineering, 2005
- Drying Kinetics of Sludge from a Wastewater Treatment PlantDrying Technology, 2004
- Moisture distribution in activated sludges: a reviewWater Research, 2004
- Optimization of heat pump fruit dryersJournal of Food Engineering, 2003