Numerical and Experimental Characterization of the Reconstructed Heat Flux Using Slug Calorimeters
Preprint
- 29 July 2026
- preprint
- Published by Elsevier in SSRN Electronic Journal
Abstract
Cold-wall heat flux is a key quantity for characterizing ground test facilities used to investigatethermal protection materials. Slug calorimeters provide a simple and reliable method to measurethis quantity through the analysis of the heating rate of a solid slug exposed to a heat input. Inthis study, several slug calorimeter configurations were investigated, including designs featuringsurface coatings on the slug front face. Thermal simulationswere performed across a dimensionalhierarchy from one to three dimensions to assess the influence of factors affecting the heat fluxreconstructed from back face temperature measurements. These factors include temperaturedependentspecific heat, conductive heat losses, sample geometry, heat flux distribution, andcoating thickness. The simulations were conducted over a wide range of heat fluxes to developcorrection curves for correcting experimentally reconstructed heat flux values. A dedicatedexperimental setup was also developed to characterize the calorimeter response. The setupconsists of a 1 kW continuous-wave collimated laser used as a controlled heat-flux source fora slug calorimeter installed inside a vacuum chamber. Excellent agreement over a heat fluxrange of 25–1000 W∕cm2 was found between calibrated input infrared flux and the heat fluxreconstructed by the slug, demonstrating the ability of the numerical models to quantify andcorrect the dominant error mechanisms affecting the reconstructed heat flux.Keywords
This publication has 33 references indexed in Scilit:
- Multi-domain analysis and prediction of inductively coupled plasma jet dynamics via high-speed imaging of visible light emissionExperimental Thermal and Fluid Science, 2024
- Stability and characterisation of Pyromark 2500 cured at different temperaturesSolar Energy, 2023
- Duplication of hypersonic stagnation-region aerothermochemistry and gas-surface interaction in high-enthalpy ground testingExperiments in Fluids, 2021
- A quasi-one-dimensional model for hypersonic reactive flow along the stagnation streamlineChinese Journal of Aeronautics, 2016
- CRC Handbook of Chemistry and Physics2014
- The Zirconia–Hafnia System: DTA Measurements and Thermodynamic CalculationsJournal of the American Ceramic Society, 2006
- Flight Extrapolation of Plasma Wind Tunnel Stagnation Region FlowfieldJournal of Thermophysics and Heat Transfer, 2006
- Temperature solution in multi-dimensional multi-layer bodiesInternational Journal of Heat and Mass Transfer, 2002
- The effect of grain size, porosity and yttria content on the thermal conductivity of nanocrystalline zirconiaScripta Materialia, 1998
- Conditions of simulation of stagnation point heat transfer from a high-enthalpy flowFluid Dynamics, 1993