Influence of tube and particle diameter on heat transport in packed beds
Authors:
- 1 May 1992
- journal article
- review article
- Published by Wiley in AIChE Journal
- Vol. 38 (5) , 703-715
Abstract
Influence of the tube and particle diameter and shape, as well as their ratio, on the radial heat transport in packed beds has been studied. Heat transport experiments were performed with four different packings in three wall‐cooled tubes, which differed in inner diameter only. Experimental values for the effective radial heat conductivity and wall heat‐transfer coefficient for the pseudo‐homogeneous two‐dimensional model and the overall heat‐transfer coefficient for the one‐dimensional model are presented. Values were obtained for glass spheres, alumina cylinders, and alumina Raschig rings. The effective radial heat conductivity and wall heat‐transfer coefficient can both be correlated as a linear function of the gas flow rate. The Bodenstein number for heat at fully developed turbulent flow is influenced strongly by the shape of the packing: 10.9 for glass spheres, 7.6 for alumina cylinders, and 4.2 for alumina Raschig rings. For the same packing, no significant influence is found of the tube diameter on the effective radial heat conductivity or on the wall heat‐transfer coefficient. The overall heat‐transfer coefficient can be described very well by the so‐called “lump equation,” which gives the relations among the overall heat‐transfer coefficient, effective radial heat conductivity, and wall heat‐transfer coefficient. The “lump factor,” as used in the lump equation, has a best‐fit experimental value of 7.4.Keywords
This publication has 67 references indexed in Scilit:
- Packed bed thermal dispersion models and consistent sets of coefficientsChemical Engineering and Processing - Process Intensification, 1989
- STEADY AND NON-STEADY STATE MODELING OF TUBULAR FIXED BED REACTORSChemical Engineering Communications, 1989
- STEADY STATE AND DYNAMIC MODELLING OF A PACKED BED REACTOR FOR THE PARTIAL OXIDATION OF METHANOL TO FORMALDEHYDE II. EXPERIMENTAL RESULTS COMPARED WITH MODEL PREDICTIONSChemical Engineering Communications, 1989
- STEADY STATE AND DYNAMIC MODELLING OF A PACKED BED REACTOR FOR THE PARTIAL OXIDATION OF METHANOL TO FORMALDEHYDE I. MODEL DEVELOPMENTChemical Engineering Communications, 1989
- THERMAL PARAMETER SENSITIVITY IN THE SIMULATION OF THE NON-ISOTHERMAL, NON-ADIABATIC FIXED BED CATALYTIC REACTOR—THE TWO-DIMENSIONAL HETEROGENEOUS MODELChemical Engineering Communications, 1987
- Remarks upon thermokinetic parameters of the one-and two-dimensional mathematical models of heat transfer in a tubular flow apparatus with a packed bedChemical Engineering and Processing - Process Intensification, 1987
- The length effect on packed bed effective heat transfer parametersThe Chemical Engineering Journal, 1985
- Wall-to-fluid coefficients for fixed bed heat and mass transferInternational Journal of Heat and Mass Transfer, 1985
- Solid conduction in low dt/dp beds of spheres, pellets and ringsInternational Journal of Heat and Mass Transfer, 1985
- Fluid-phase radial transport in packed beds of low tube-to-particle diameter ratioInternational Journal of Heat and Mass Transfer, 1984