Black P/graphene hybrid: A fast response humidity sensor with good reversibility and stability
Open Access
- 5 September 2017
- journal article
- research article
- Published by Springer Nature in Scientific Reports
- Vol. 7 (1) , 1-7
Abstract
Black phosphorus (BP) materials have attracted considerable attention owing to their ultra-sensitive humidity sensing characteristics because of the natural absorption of water (H2O) molecules on the BP surface caused by the specific 2D layer-crystalline structure. On the other hand, the BP-based humidity sensor is less repeatable due to the instability of BP with water molecules and the stability of the sensor is reduced. In this study, this limitation of the BP-based humidity sensor was overcome by preparing a BP/graphene hybrid as a novel humidity sensing nanostructure. The BP/graphene interface improved the stability of the humidity sensor after a few weeks with a linear response within the relative humidity (RH) range of 15–70%. The sensor’s response/recovery speed of the humidity sensor was extremely fast within few seconds. The response (S) of the humidity sensor based on the BP/graphene hybrid is 43.4% at RH = 70%. The estimated response and recovery time of the sensor is only 9 and 30 seconds at RH = 70% at room temperature. The experimental investigation reveals that the BP/graphene hybrid not only improves the reversibility and hysteresis factors but also enhances the stability of the humidity sensor.Keywords
This publication has 23 references indexed in Scilit:
- Recent trends of ceramic humidity sensors development: A reviewSensors and Actuators B: Chemical, 2016
- Fabrication and characterization of an ultrasensitive humidity sensor based on metal oxide/graphene hybrid nanocompositeSensors and Actuators B: Chemical, 2016
- Role of nanostructured polymers on the improvement of electrical response-based relative humidity sensorsSensors and Actuators B: Chemical, 2016
- Effects of rapid thermal annealing on humidity sensor based on graphene oxide thin filmsSensors and Actuators B: Chemical, 2015
- Inside Back Cover: Layered Black Phosphorus as a Selective Vapor Sensor (Angew. Chem. Int. Ed. 48/2015)Angewandte Chemie International Edition, 2015
- Liquid exfoliation of solvent-stabilized few-layer black phosphorus for applications beyond electronicsNature Communications, 2015
- Two-Dimensional Materials for Sensing: Graphene and BeyondElectronics, 2015
- Opto-electronic humidity sensor: A reviewSensors and Actuators A: Physical, 2015
- Phosphorene as a Superior Gas Sensor: Selective Adsorption and Distinct I–V ResponseThe Journal of Physical Chemistry Letters, 2014
- High-sensitivity humidity sensors with ZnO nanorods based two-port surface acoustic wave delay lineSensors and Actuators B: Chemical, 2012