Valorization of Tomato Stem Waste: Biochar as a Filler in Three-Dimensional Printed PLA Composites
Authors:
Open Access
- 23 September 2025
- Vol. 17 (19) , 2565
Abstract
This study explores the valorization of tomato stem waste by converting it into biochar through slow pyrolysis and incorporating it into poly(lactic acid) (PLA) composites for fused filament fabrication (FFF) 3D printing. The objective was to improve the valorization and added value of tomato stem waste. Biochar derived from tomato stems was characterized for its physicochemical properties, revealing a high surface area and small particle size. PLA-based composite filaments with 5% and 7.5% biochar were manufactured via melt extrusion. The effects of biochar concentration and printing infill patterns (concentric and rectilinear) on the mechanical and thermomechanical properties of the 3D-printed composites were investigated. Results indicated that biochar slightly increased the glass transition temperature of PLA and improved the flexural properties. Dynamic mechanical analysis (DMA) showed that the storage modulus was enhanced in the glassy region for composites with 5% biochar, suggesting improved stiffness. This research demonstrates the potential of using tomato stem-derived biochar as a sustainable filler in PLA composites, contributing to the circular economy and reducing environmental impact.Keywords
Funding Information
- HORIZON EUROPE Framework Programme (101135505)
This publication has 95 references indexed in Scilit:
- Optimization of Compressive Strength Properties in Fused Deposition Modeling 3D Printed PLA / HA Composites for Bone Tissue Engineering ApplicationsEngineering Reports, 2025
- Development and characterization of groundnut shell‐derived biocarbon‐reinforced polylactic acid composite filaments for FDMJournal of Applied Polymer Science, 2024
- Biochar as construction materials for achieving carbon neutralityBiochar, 2022
- Hydrothermal carbonization of oil palm trunk via taguchi methodKorean Journal of Chemical Engineering, 2021
- Effect of Infill Ratio on the Tensile and Flexural Properties of Unreinforced and Carbon Fiber-Reinforced Polylactic Acid Manufactured by Fused Deposition ModelingJournal of Materials Engineering and Performance, 2021
- Use of Biochar for Sustainable Ferrous MetallurgyJOM, 2019
- Mechanical properties of PLA-graphene filament for FDM 3D printingThe International Journal of Advanced Manufacturing Technology, 2019
- Past, present, and future of biocharBiochar, 2019
- Additive manufacturing: technology, applications and research needsFrontiers of Mechanical Engineering, 2013
- Effects of talc on the mechanical and thermal properties of polylactideJournal of Applied Polymer Science, 2012