Photovoltaic Cooling Utilizing Phase Change Materials
Authors:
Open Access
- 25 March 2020
- conference paper
- Published by EDP Sciences in E3S Web of Conferences
- Vol. 160, 02004
Abstract
A theoretical analysis based on mathematical formulations and experimental test to a photovoltaic system cooled by Phase Change Material (PCM) is carried out and documented. The PCM is attached to the back of the PV panel to control the temperature of cells in the PV panel. The experimental tests were done to solar systems with and without using PCM for comparison purposes. A PCM of paraffin graphite panels of thickness15 mm has covered the back of the panel. This layer was covered with an aluminum sheet fixed tightly to the panel frame. In the experimental test, it was found that when the average cell temperature exceeds the melting point temperature of the PCM, the efficiency of the system increases. However, when the cell temperature did not exceed the melting temperature of the PCM, the use of the PCM will affect negatively the system efficiency.Keywords
This publication has 21 references indexed in Scilit:
- ANALYSIS OF EFFECTS OF SOLAR IRRADIANCE, CELL TEMPERATURE AND WIND SPEED ON PHOTOVOLTAIC SYSTEMS PERFORMANCEInternational Journal of Energy Economics and Policy, 2020
- Investigation of Repurposed Material Utilization for Environmental Protection and Reduction of Overheat Power Losses in PV PanelsInternational Journal of Photoenergy, 2019
- Transient heat transfer for the cooling of PVC tubes using water jetExperimental Thermal and Fluid Science, 2018
- A novel hybrid photovoltaics/thermoelectric cooler distillation systemInternational Journal of Energy Research, 2018
- Energy and water as indicators for sustainable city site selection and design in Jordan using smart gridSustainable Cities and Society, 2018
- Temperature and wind speed impact on the efficiency of PV installations. Experience obtained from outdoor measurements in GreeceRenewable Energy, 2014
- Water immersion cooling of PV cells in a high concentration systemSolar Energy Materials and Solar Cells, 2011
- Handbook of Photovoltaic Science and Engineering2010
- Optimal sizing of a grid-connected PV system for various PV module technologies and inclinations, inverter efficiency characteristics and locationsRenewable Energy, 2010
- Enhanced heat dissipation of V-trough PV modules for better performanceSolar Energy Materials and Solar Cells, 2008