New Technique for Synthesizing Concurrent Dual-Band Impedance-Matching Filtering Networks and ${\hbox{0.18-}}\mu{\hbox {m}}$ SiGe BiCMOS 25.5/37-GHz Concurrent Dual-Band Power Amplifier
Authors:
- 23 September 2013
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 61 (11) , 3927-3939
Abstract
New technique for synthesizing concurrent dual-band impedance-matching filtering networks is presented. The technique enables the design of concurrent dual-band impedance-matching filtering networks that provide not only simultaneous matching of two arbitrary loads to two arbitrary sources at two different frequencies, but also dual-bandpass filtering response capable of suppressing unwanted signals like the harmonics and inter-modulation products in nonlinear circuits, such as power amplifiers (PAs). A new 0.18-μm SiGe BiCMOS concurrent dual-band PA was designed based on the developed dual-band matching filtering technique around 25.5 and 37 GHz, which works in the concurrent dual-band mode (25.5 and 37 GHz), as well as single-band mode (25.5 or 37 GHz). The measured results show that, in the single-band mode, the dual-band PA exhibits gain of 21.4 and 17 dB, maximum output power of 16 and 13 dBm, and maximum power-added efficiency (PAE) of 10.6% and 4.9% at 25.5 and 37 GHz, respectively. In the dual-band mode, the maximum output power is 13 and 9.5 dBm at 25.5 and 37 GHz, respectively, and the total maximum PAE is 7.1%. The designed concurrent dual-band PA has a chip size of 1.3×0.68 mm 2 and consumes a dc current of 120 mA from a 3-V supply voltage.Keywords
This publication has 21 references indexed in Scilit:
- A Dual-Band 10/24-GHz Amplifier Design Incorporating Dual-Frequency Complex Load MatchingIEEE Transactions on Microwave Theory and Techniques, 2012
- Dual-band matching technique based on dual-characteristic impedance transformers for dual-band power amplifiers designIET Microwaves, Antennas & Propagation, 2011
- Dual-Band Impedance Transformer Using Two-Section Shunt StubsIEEE Transactions on Microwave Theory and Techniques, 2010
- A Generalized Dual-Frequency Transformer for Two Arbitrary Complex Frequency-Dependent ImpedancesIEEE Microwave and Wireless Components Letters, 2009
- A Monolithic 24 GHz, 20 dBm, 14% PAE SiGe HBT Power Amplifier2006
- A 21-26-GHz SiGe bipolar power amplifier MMICIEEE Journal of Solid-State Circuits, 2005
- A 24-GHz, +14.5-dBm fully integrated power amplifier in 0.18-/spl mu/m CMOSIEEE Journal of Solid-State Circuits, 2005
- Design of 24 GHz SiGe HBT balanced power amplifier for system-on-a-chip ultra-wideband applications2005
- High-Frequency Solid-State Electronic DevicesIEEE Transactions on Electron Devices, 2005
- 24 and 36 GHz SiGe HBT power amplifiers2004