Three-dimensional features of void morphology in resin transfer molded composites
Authors:
- Youssef K. HamidiYHYoussef K. Hamidi
- Levent AktasLALevent Aktas
- M. Cengiz AltanMAM. Cengiz Altan
- 1 June 2005
- journal article
- Published by Elsevier in Composites Science and Technology
- Vol. 65 (7-8) , 1306-1320
Abstract
No abstract availableKeywords
This publication has 27 references indexed in Scilit:
- Modeling and simulation approaches in the resin transfer molding process: A reviewPolymer Composites, 2003
- Effect of Injection Rate and Post-Fill Cure Pressure on Properties of Resin Transfer Molded DisksJournal of Composite Materials, 2002
- A comparison of physical properties of glass fibre epoxy composites produced by wet lay-up with autoclave consolidation and resin transfer mouldingComposites Part A: Applied Science and Manufacturing, 1998
- Measurement of void collapse during resin transfer mouldingComposites Part A: Applied Science and Manufacturing, 1997
- Experimental investigation of flow‐induced microvoids during impregnation of unidirectional stitched fiberglass matPolymer Composites, 1996
- Modeling of void formation and removal in liquid composite molding. Part I: Wettability analysisPolymer Composites, 1996
- Effects of fiber mat architecture on void formation and removal in liquid composite moldingPolymer Composites, 1995
- Micro scale flow behavior and void formation mechanism during impregnation through a unidirectional stitched fiberglass matPolymer Engineering & Science, 1995
- Quantitative measurement of voids formed during liquid impregnation of nonwoven multifilament glass networks using an optical visualization techniquePolymer Engineering & Science, 1992
- A Note on the Effects of Voids Upon the Hygral and Mechanical Properties of AS4/3502 Graphite/EpoxyJournal of Composite Materials, 1987