Design and preliminary evaluation of a flexible exoskeleton to assist with lifting
Open Access
- 1 January 2020
- journal article
- research article
- Published by Cambridge University Press (CUP) in Wearable Technologies
- Vol. 1
Abstract
We present a passive (unpowered) exoskeleton that assists the back during lifting. Our exoskeleton uses carbon fiber beams as the sole means to store energy and return it to the wearer. To motivate the design, we present general requirements for the design of a lifting exoskeleton, including calculating the required torque to support the torso for people of different weights and heights. We compare a number of methods of energy storage for exoskeletons in terms of mass, volume, hysteresis, and cycle life. We then discuss the design of our exoskeleton, and show how the torso assembly leads to balanced forces. We characterize the energy storage in the exoskeleton and the torque it provides during testing with human subjects. Ten participants performed freestyle, stoop, and squat lifts. Custom image processing software was used to extract the curvature of the carbon fiber beams in the exoskeleton to determine the stored energy. During freestyle lifting, it stores an average of 59.3 J and provides a peak torque of 71.7 Nm.Keywords
This publication has 52 references indexed in Scilit:
- PLAD (personal lift assistive device) stiffness affects the lumbar flexion/extension moment and the posterior chain EMG during symmetrical lifting tasksJournal of Electromyography and Kinesiology, 2009
- Effects of shot-peening and re-shot-peening on four-point bend fatigue behavior of Ti–6Al–4VMaterials Science and Engineering: A, 2007
- Fatigue analysis of unidirectional GFRP composites under combined bending and torsional loadsComposite Structures, 2007
- Analysis of squat and stoop dynamic liftings: muscle forces and internal spinal loadsEuropean Spine Journal, 2006
- Analysis of Fatigue Life under Complex Loading: Revisiting Cadwell, Merrill, Sloman, and YostRubber Chemistry and Technology, 2006
- Relation between spinal load factors and the high-risk probability of occupational low-back disorderErgonomics, 1999
- Influence of lumbar and hip mobility on the bending stresses acting on the lumbar spineClinical Biomechanics, 1993
- Influence of body segment dynamics on loads at the lumbar spine during liftingErgonomics, 1992
- Inertial effects from single body segments in dynamic analysis of liftingErgonomics, 1991
- Relationship between moments at the L5/S1 level, hip and knee joint when liftingJournal of Biomechanics, 1990