Combined resistive and laser heating technique for in situ radial X-ray diffraction in the diamond anvil cell at high pressure and temperature
Authors:
- 1 February 2013
- journal article
- conference paper
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 84 (2) , 025118
Abstract
To extend the range of high-temperature, high-pressure studies within the diamond anvil cell, a Liermann-type diamond anvil cell with radial diffraction geometry (rDAC) was redesigned and developed for synchrotron X-ray diffraction experiments at beamline 12.2.2 of the Advanced Light Source. The rDAC, equipped with graphite heating arrays, allows simultaneous resistive and laser heating while the material is subjected to high pressure. The goals are both to extend the temperature range of external (resistive) heating and to produce environments with lower temperature gradients in a simultaneously resistive- and laser-heated rDAC. Three different geomaterials were used as pilot samples to calibrate and optimize conditions for combined resistive and laser heating. For example, in Run#1, FeO was loaded in a boron-mica gasket and compressed to 11 GPa then gradually resistively heated to 1007 K (1073 K at the diamond side). The laser heating was further applied to FeO to raise temperature to 2273 K. In Run#2, Fe–Ni alloy was compressed to 18 GPa and resistively heated to 1785 K (1973 K at the diamond side). The combined resistive and laser heating was successfully performed again on (Mg0.9Fe0.1)O in Run#3. In this instance, the sample was loaded in a boron-kapton gasket, compressed to 29 GPa, resistive-heated up to 1007 K (1073 K at the diamond side), and further simultaneously laser-heated to achieve a temperature in excess of 2273 K at the sample position. Diffraction patterns obtained from the experiments were deconvoluted using the Rietveld method and quantified for lattice preferred orientation of each material under extreme conditions and during phase transformation.Keywords
Funding Information
- U.S. Department of Energy (DEAC02-05CH11231)
- National Science Foundation (EAR 0836402, EAR 10-43050)
This publication has 50 references indexed in Scilit:
- Significance of mechanical twinning in hexagonal metals at high pressureActa Materialia, 2012
- Slip Systems in MgSiO 3 Post-Perovskite: Implications for D ′′ AnisotropyScience, 2010
- In situ phase transformation and deformation of iron at high pressure and temperatureJournal of Applied Physics, 2008
- Deformation textures produced in diamond anvil experiments, analysed in radial diffraction geometryJournal of Physics: Condensed Matter, 2006
- Plastic Deformation of MgGeO 3 Post-Perovskite at Lower Mantle PressuresScience, 2006
- In situ observation of texture development in olivine, ringwoodite, magnesiowüstite and silicate perovskite at high pressureEarth and Planetary Science Letters, 2004
- The deformation-DIA: A new apparatus for high temperature triaxial deformation to pressures up to 15 GPaReview of Scientific Instruments, 2003
- High-pressure rotational deformation apparatus to 15 GPaReview of Scientific Instruments, 2001
- X-ray Imaging of Stress and Strain of Diamond, Iron, and Tungsten at Megabar PressuresScience, 1997
- The lattice strains in a specimen (cubic system) compressed nonhydrostatically in an opposed anvil deviceJournal of Applied Physics, 1993