A novel method for reducing the defocus error of a five-degree-of-freedom measurement system
Authors:
- 8 July 2022
- conference paper
- Published by SPIE-Intl Soc Optical Eng
- Vol. 12282, 24-74
Abstract
Multi-degree-of-freedom measurement (MDFM) system is an effective way to measure multiple degrees of freedom errors simultaneously. In the MDFM system, the pitch angle and yaw angle are often measured based on the autocollimation measurement principle. Due to the lens fabrication and installation errors, the angle detector will deviate from the focal plane, causing defocus error. To address the problem, a defocus error model is established to analyze the influencing factors and solve the position of the focal plane. It is found that the straightness is the main factor of defocus error. When the defocus amount is present, the defocus error is larger with the increase of straightness. And the sensitivity of angle detector has a specific relationship with the intensity density of spot, which is related to the defocus amount. By using a precision displacement table, the position of the focal plane and the corresponding angle detector output can be accurately obtained. The experiment was carried out to verify the feasibility of this method. The angle detector and lens were installed precisely according to the angle detector output. When the vertical straightness is within ±400 μm, the influence of the defocus error on the pitch angle is less than 2 μrad. The results showed that the method can reduce the defocus error of auto-collimation measurement effectively, which can improve the accuracy of angle measurement in MDFM system.Keywords
This publication has 11 references indexed in Scilit:
- Effect of detector installation error on the measurement accuracy of multi-degree-of-freedom geometric errors of a linear axisMeasurement Science and Technology, 2020
- Low cost, compact 4-DOF measurement system with active compensation of beam angular drift errorOptics Express, 2018
- Development of a simple system for simultaneously measuring 6DOF geometric motion errors of a linear guideOptics Express, 2013
- Five-degrees-of-freedom measurement system based on a monolithic prism and phase-sensitive detection techniqueApplied Optics, 2013
- Focal shift of focused flat-topped beamsOptics Communications, 1998
- A six-degree-of-freedom measurement system for the motion accuracy of linear stagesInternational Journal of Machine Tools and Manufacture, 1998
- An On-Line Measurement Technique for Machine Volumetric Error CompensationJournal of Engineering for Industry, 1993
- Focal shift in Laguerre–Gaussian beamsJournal of the Optical Society of America A, 1987
- Focal shift in focused truncated gaussian beamsOptics Communications, 1982
- Focal shifts in diffracted converging spherical wavesOptics Communications, 1981